AdamLoi

#include <OneWire.h>
#include <DallasTemperature.h>

// Data wire is plugged into port 2 on the Arduino
#define ONE_WIRE_BUS 2

// Setup a oneWire instance to communicate with any OneWire devices (not just Maxim/Dallas temperature ICs)
OneWire oneWire(ONE_WIRE_BUS);

// Pass our oneWire reference to Dallas Temperature. 

AdamLoi

//GRobotronics 28-5-2014

// Arduino pins connected to the 4511
const uint8_t LedA = 5;
const uint8_t LedB = 8;
const uint8_t LedC = 7;
const uint8_t LedD = 6;

// Arduino pins connected to the segment driver transistors
const uint8_t Led1 = 1;

AdamLoi

//GRobotronics 29/3/2014


unsigned char i;
unsigned char j; 
/*Port Definitions*/
int Max7219_pinCLK = 2;
int Max7219_pinCS = 1;
int Max7219_pinDIN = 0;

AdamLoi

#include <Wire.h>
#include <i2ckeypad.h>

#define ROWS 4
#define COLS 3

// With A0, A1 and A2 of PCF8574 to ground I2C address is 0x38
#define PCF8574_ADDR 0x38

AdamLoi

#include <TinyWireM.h>                 
#include <LiquidCrystal_I2C.h>         

LiquidCrystal_I2C lcd(0x20,16,2);  // set address & 16 chars / 2 lines

void setup()
{

  TinyWireM.begin();                    // initialize I2C lib
  lcd.init();                           // initialize the lcd 

AdamLoi

/* YourDuino.com Example Software Sketch
 IR Remote Kit Test
 Uses YourDuino.com IR Infrared Remote Control Kit 2
 http://arduino-direct.com/sunshop/index.php?l=product_detail&p=153
 based on code by Ken Shirriff - http://arcfn.com
 Get Library at: https://github.com/shirriff/Arduino-IRremote
 Unzip folder into Libraries. RENAME folder IRremote
 [email protected] */

/*-----( Import needed libraries )-----*/

AdamLoi

/*================================================================
This demo code shows how to use the touch screen in TFT01
The LCD connection is the same as that in “8 Bit Pant Demo“
 
by Elecfreaks
================================================================*/
 
#define LCD_RS   19         
#define LCD_WR   18     
#define LCD_CS   17