EiNSTeiN- / mtrack_surface_book.md

Last active February 14, 2017 21:34

Installing mtrack touchpad driver on Surface Book

Remove synaptics driver

sudo apt autoremove xserver-xorg-input-synaptics

Install mtrack dependencies

sudo apt build-dep xserver-xorg-input-mtrack

Clone mtrack source code

EiNSTeiN- / Ubuntu 16.04 on a Surface Book.md

Last active April 20, 2017 02:08

My notes to get decent hardware support with Ubuntu 16.04 for my Surface Book

Get a functional kernel

sudo apt-add-repository ppa:tigerite/kernel

Fix up the weird lock screen bug in cinnamon-screensaver

EiNSTeiN- / TapChanger new extruder notes.md

Last active November 1, 2024 12:01

Steps for installing a new extruder onto a TapChanger v0.2.5

Steps for configuring a new extruder onto a TapChanger v0.2.5

Re-tighten your carriage screws, this can be a cause of non-repeatable homing.
If you use sensorless homing: make sure there is no occasional skipping while either axis are being homed! This may cause misalignment. If that is the case, lower the homing_speed in your printer's [stepper_x]/[stepper_y] configs.
Check your homing routine, ensure it homes Y before X, otherwise you may accidentally bump into docked tools, or you may get interference from the Y tensionner if you home X too close to the front of the printer.