MercilessWaysDesigns MercilessWaysDesigns
justheath
/ printer.cfg
Created
April 22, 2023 15:50
Ender 3 Pro config with Creality 4.2.7, TH3D EZABL, Sprite Extruder
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| # This file came from https://github.com/Klipper3d/klipper/blob/master/config/generic-creality-v4.2.7.cfg | |
| # This file contains pin mappings for the Creality "v4.2.7" board. To | |
| # use this config, during "make menuconfig" select the STM32F103 with | |
| # a "28KiB bootloader" and serial (on USART1 PA10/PA9) communication. | |
| # Flash this firmware by copying "out/klipper.bin" to a SD card and | |
| # turning on the printer with the card inserted. The firmware | |
| # filename must end in ".bin" and must not match the last filename | |
| # that was flashed. |