Disclaimer: You are going to mess with your hardware and the lowest levels of your device. You should be somewhat savvy with the command line. I'm not responsible for any damage.
Warning: this document has to be updated by pointing to https://github.com/SpenceKonde/ATTinyCore
This note describes the configuration of an ATtiny85 based microcontroller development board named Digispark and similar to the Arduino line. It is available in many online marketplaces for roughly 1 dollar (e.g., Ebay, Amazon, AliExpress) and is shipped fully assembled, including a V-USB interface (a software-only implementation of a low-speed USB device for Atmel's AVR microcontrollers). Coding is similar to Arduino: it uses the familiar Arduino IDE and is already provided with a ready-to-use bootloader (
| ; This is the newest FAST User.cfg BoredGamer has made as of 28th September 2015 | |
| ; Custom User.cfg - This is a command that used to unlock the console to allow commands, I just leave it here in case they change it in a patch so that you need it again! | |
| Con_Restricted = 0 | |
| ; This Setting basically sets the basis for your config, 1-4, 1 is Low but best performance & 4 is Very High Graphics but most intensive. It sets loads of settings & it’s important it’s at the top of the .cfg so that anything below it overwrites parts of it. | |
| sys_spec = 1 | |
| ; Remove Maxfps to have a less stable max framerate (but it will be at it’s highest), I suggest setting at an achievable level, slower PCs go for 30, Fast PCs set at your monitors Refresh rate. If unsure delete it. | |
| sys_maxfps = 60 |
| Guide & Discussion Thread: | |
| http://forum.netkas.org/index.php?topic=874.0 | |
| http://forum.netkas.org/index.php?action=printpage;topic=874.0 | |
| For the best guide, use search keyword: chmod. Scrolls down to --> | |
| Post by: Shinso on September 18, 2012, 07:28:35 PM | |
| Post by: Shinso on September 18, 2012, 07:30:19 PM | |
| * First: upgrade cpu to Core2Duo |
| import imaplib | |
| import email | |
| #connect to gmail | |
| mail = imaplib.IMAP4_SSL('imap.gmail.com') | |
| mail.login('[email protected]','yourPassWordPlease') | |
| mail.select('inbox') | |
| mail.list() |
| import imaplib | |
| import email | |
| #connect to gmail | |
| mail = imaplib.IMAP4_SSL('imap.gmail.com') | |
| mail.login('[email protected]','your_password') | |
| mail.select('inbox') | |
| mail.list() | |
