Lachie lachiefish
jazzsequence
/ end.gcode
Last active
October 24, 2024 22:42
Start and End G-code for Ender 5 on Cura
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| ; Ender 5 Custom End G-code | |
| G4 ; Wait | |
| M220 S100 ; Reset Speed factor override percentage to default (100%) | |
| M221 S100 ; Reset Extrude factor override percentage to default (100%) | |
| G91 ; Set coordinates to relative | |
| G1 F1800 E-3 ; Retract filament 3 mm to prevent oozing | |
| G1 F3000 Z20 ; Move Z Axis up 20 mm to allow filament ooze freely | |
| G90 ; Set coordinates to absolute | |
| G1 X0 Y220 F1000 ; Move Heat Bed to the front for easy print removal | |
| M106 S0 ; Turn off cooling fan |