Skip to content

Instantly share code, notes, and snippets.

View luminouw's full-sized avatar

luminouw

0 followers · 8 following
View GitHub Profile
@faparicior
faparicior / end.gcode
Created April 28, 2020 16:03
Start and End G-code for Ender 3 on Cura
; Ender 3 Custom End G-code
G4 ; Wait
M220 S100 ; Reset Speed factor override percentage to default (100%)
M221 S100 ; Reset Extrude factor override percentage to default (100%)
G91 ; Set coordinates to relative
G1 F1800 E-3 ; Retract filament 3 mm to prevent oozing
G1 F3000 Z20 ; Move Z Axis up 20 mm to allow filament ooze freely
G90 ; Set coordinates to absolute
G1 X0 Y{machine_depth} F1000 ; Move Heat Bed to the front for easy print removal
M106 S0 ; Turn off cooling fan
@equipter
equipter / SAK Switching.md
Last active October 14, 2024 04:17
Explaination of Mifare Classic SAK Swapping anti cloning defense

Mifare Classic - SAK Swapping Explained

What is SAK Swapping

Behaviour has been observered where some system using Mifare Classic credentials will identify with one SAK (0x08/18) on a basic search (Wake up) but when the block 0 is dumped, the SAK appears to be different (0x88/0x98)

This is because the SAK reported on a Wake up is not coming from Block 0 but is instead burned into the card, The SAK in Block 0 is merely a Vanity SAK.

If the dump is loaded onto a Magic Mifare Classic that Mirrors the vanity SAK as the actual SAK on Wake up it will tell the system that the credential is a duplicate & to deny access.