arthurlevy

%GMSH2PDETOOLBOX Reads a mesh in msh format, version 1 or 2 and returns the
%arrays p, e and t according to the MATLAB pde toolbox syntax. Filename
%refers to the .msh file. Note that only triangular 2D mesh are processed
%since these are the only elements allowed in pde toolbox.
%
%SEE ALSO load_gmsh load_gmsh4 initmesh
%
% Copyright (C) 2014 Arthur Levy. https://github.com/arthurlevy/
%
% This fucntion uses the routine load_gmsh4 in load_gmsh2.m: Copyright (C)

mhitza

%.hex: %.asm
	avra -fI $<
	rm *.eep.hex *.obj *.cof

all: $(patsubst %.asm,%.hex,$(wildcard *.asm))

upload: ${program}.hex
	avrdude -c arduino -p m328p -P /dev/arduino-uno -b 115200 -U flash:w:$<

monitor:

jFransham

Achieving warp speed with Rust

Contents:

• Number one optimization tip: don't
• Never optimize blindly
• Don't bother optimizing one-time costs
• Improve your algorithms
• CPU architecture primer
• Keep as much as possible in cache
• Keep as much as possible in registers

HadrienG2

Hello, Rust community!

My name is Hadrien and I am a software performance engineer in a particle physics lab. My daily job is to figure out ways to make scientific software use hardware more efficiently without sacrificing its correctness, primarily by adapting old-ish codebases to the changes that occured in the software and computing landscape since the days where they were designed:

• CPU clock rates and instruction-level parallelism stopped going up, so optimizing code is now more important.
• Multi-core CPUs went from an exotic niche to a cheap commodity, so parallelism is not optional anymore.
• Core counts grow faster than RAM prices go down, so multi-processing is not enough anymore.
• SIMD vectors become wider and wider, so vectorization is not a gimmick anymore.