Nico ramicaza
ramicaza
/ GT511-C1 and ATtiny
Last active
October 22, 2015 15:07
This is a sketch that allows the ATtiny line of micro controllers to interface with the GT511-C1/3 fingerprint sensor from Sparkfun. The advantage of this sketch is that it requires no libraries and thus works on any board that can be programmed with the Arduino IDE. The sketch initializes the connection with the sensor, turns the sensors in-bui…
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| #define greenLed 4 //this lights up when a registered user places their thumb | |
| #define redLed 3 //this is on until a registerd user places their thumb | |
| #define relay 2 //this pin goes HIGH when the registered thumb is placed | |
| #define rxPin 0 //this goes to the TX pin of the FP sensor | |
| #define txPin 1 //this goes to the RX pin of the FP sensor | |
| #include <SoftwareSerial.h>; | |
| SoftwareSerial mySerial(rxPin, txPin); | |
| byte zero = 0; |
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| #!/usr/bin/python3 | |
| import cv2 | |
| import numpy as np | |
| def transformBound(rect,xs,ys): | |
| x,y,w,h = rect | |
| xt = int(round(x + (w-w*xs)/2)) | |
| wt = int(round(w*xs)) | |
| yt = int(round(y + (h-h*ys)/2)) | |
| ht = int(round(h*ys)) |