Vladyslav Pavlov vladyspavlov

vladyspavlov / ld2410c.yaml

Created December 30, 2023 16:43

ESPHome configuration, LD2410C and Wemos D1 Mini Pro (ESP8266)

vladyspavlov / 1ch-relay.yaml

Last active August 29, 2024 10:56

ESPHome configuration for 1-channel ESP32 relay from AliExpress with a 90-250VAC power supply. SZHJW ESP32_Relay_AC X1_V1.1 (303E32AC111)

	# https://www.aliexpress.com/item/1005005848983315.html
	# Pinout:
	# GPIO0 - Button
	# GPIO16 - Relay
	# GPIO23 - LED
	# ESP: ESP32-WROOM-32E (ESP32-D0WD V3, rev. 3.1)

	substitutions:
	name: 1ch-relay
	friendly_name: 1CH Relay

vladyspavlov / timedelta.yaml

Created November 25, 2023 15:13

Home Assistant. Example of dividing time between entity last changes and converting to human readable

	{% set td = trigger.to_state.last_changed - trigger.from_state.last_changed %}
	{% set ts = td.total_seconds() \| int %}
	{% set hours, remainder = (ts // 3600, ts % 3600) %}
	{% set minutes, seconds = (remainder // 60, remainder % 60) %}
	Days: {{ td.days }}, hours: {{ hours }}, minutes: {{ minutes }}, seconds: {{ seconds }}

vladyspavlov / telegram.yaml

Created November 2, 2023 21:37

ESPHome Telegram bot send message example

	substitutions:
	TELEGRAM_BOT_TOKEN: !secret telegram_bot_token
	api_key: !secret api_key
	ota_password: !secret ota_password
	chat_id: xxxxxxxxx

	esphome:
	name: wemos
	friendly_name: wemos

vladyspavlov / inverter-monitor.yaml

Last active November 9, 2024 21:00

Must inverter ESPHome configuration for ESP32

vladyspavlov / battery-bms-invertor.yaml

Created October 8, 2023 21:24

SRNE/Easun SMX-II ESPHome configuration

	substitutions:
	name: "Bms"
	invertor_id: "invertor"
	invertor_name: "Invertor"
	battery_coefficient: '2' # battery voltage / 12
	multiply_10: '5' # 10 / battery_coefficient
	updates: 5s

	esphome:
	name: battery-bms-invertor

vladyspavlov / dingtian-4ch.yaml

Last active November 11, 2024 20:43

ESPHome config for Dingtian 4CH Relay (dtwonder DT-R004) + Modbus NPN IO extender module

	esphome:
	name: dingtian-4ch
	friendly_name: Dingtian 4CH
	comment: "ESP32-D0WD v1.0"
	# Change NPN module modbus speed to 19200
	# Baud rate corresponds to the number: 0: 1200 1: 2400 2: 4800 3: 9600 4: 19200
	#on_boot:
	# ## configure controller settings at setup
	# ## make sure priority is lower than setup_priority of modbus_controller
	# priority: -100