Skip to content

Instantly share code, notes, and snippets.

View 4cidhead's full-sized avatar

4cidhead

0 followers · 6 following
View GitHub Profile
@4cidhead
4cidhead / install.md
Last active April 9, 2026 20:25 — forked from wjlafrance/install.md
Install proxmox on NVMe drives with USB boot disk

I'm installing Proxmox on an HP ProLiant DL360p Gen8 server, which cannot boot from NVMe. The NVMe drives are each installed on single-slot M.2 adapters in the rear PCIe slots.

  1. Install Proxmox as "zfs raid1" (their installer uses wrong terminology) on two NVMe drives. Consider turning compression off. This Proxmox installation will be the actual instance that gets used, but is not currently bootable on this system.
  2. Re-run the installer and install Proxmox on a flash drive as a single-drive zfs pool. I used 16GB, not sure if 8GB will suffice.
  3. Reboot from the flash drive. This will load grub, but throw an error there are now two pools called rpool and one of them was last imported on another system. You'll be dropped into a BusyBox shell.
  4. Import the NVMe-based pool by id. Run zpool import to list available pools, find the pool with two NVMe drives, and run zpool import -f 123456. exit the BusyBox shell, and the system will now boot the Proxmox instance installed in step 1.
  5. Grab a Proxmox
@4cidhead
4cidhead / openclaw_with_ollama.md
Created February 18, 2026 13:35 — forked from iam-veeramalla/openclaw_with_ollama.md
openclaw with ollama (Zero cost AI Assistant)

OpenClaw configuration with Ollama

Install OpenClaw

curl -fsSL https://openclaw.ai/install.sh | bash

Install Ollama

curl -fsSL https://ollama.com/install.sh | sh