You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Essentially just copy the existing video and audio stream as is into a new container, no funny business!
The easiest way to "convert" MKV to MP4, is to copy the existing video and audio streams and place them into a new container. This avoids any encoding task and hence no quality will be lost, it is also a fairly quick process and requires very little CPU power. The main factor is disk read/write speed.
With ffmpeg this can be achieved with -c copy. Older examples may use -vcodec copy -acodec copy which does the same thing.
These examples assume ffmpeg is in your PATH. If not just substitute with the full path to your ffmpeg binary.
Extracts each .spa file in Spotify's Apps directory without manually doing it yourself.
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Simple guide for setting up OTG modes on the Raspberry Pi Zero
Raspberry Pi Zero OTG Mode
Simple guide for setting up OTG modes on the Raspberry Pi Zero - By Andrew Mulholland (gbaman).
The Raspberry Pi Zero (and model A and A+) support USB On The Go, given the processor is connected directly to the USB port, unlike on the B, B+ or Pi 2 B, which goes via a USB hub.
Because of this, if setup to, the Pi can act as a USB slave instead, providing virtual serial (a terminal), virtual ethernet, virtual mass storage device (pendrive) or even other virtual devices like HID, MIDI, or act as a virtual webcam!
It is important to note that, although the model A and A+ can support being a USB slave, they are missing the ID pin (is tied to ground internally) so are unable to dynamically switch between USB master/slave mode. As such, they default to USB master mode. There is no easy way to change this right now.
It is also important to note, that a USB to UART serial adapter is not needed for any of these guides, as may be documented elsewhere across the int