pantherale0

blueprint:
  name: Philips Hue Dimmer switch v2 (Zigbee2MQTT)
  description:
    "Tested with Philips Hue Smart Wireless Dimmer Switch V2 (929002398602).
    \n\n
    To have different actions on short press and on hold (long press), use 'button release' (`*_press_release`) and 'button hold once' (`*_hold_once`) commands,
    as 'press' (`*_press`) will always trigger before 'button hold' (`*_hold`).
    \n\n
    When you hold a button, 'button hold' (`*_hold`) command is repeated roughly once per second. This may not work as desired with actions like toggling light/switch.
    If you want an action to run only once when the button hold action is registered, use 'button hold once' (`*_hold_once`). It's better than using 'button hold release'

CrazyCoder

blueprint:
  name: Philips Hue Dimmer switch v2 (Zigbee2MQTT)
  description:
    "Tested with Philips Hue Smart Wireless Dimmer Switch V2 (929002398602).
    \n\n
    Uses MQTT device triggers — select your dimmer from the device picker.
    \n\n
    After you pair a dimmer, press and release each of the four buttons, then hold and release each of them.
    Zigbee2MQTT publishes a device trigger to Home Assistant only after the device sends that action once, so this registers all 16 triggers.
    A short press sends `*_press` and `*_press_release`. A hold sends `*_press`, then `*_hold`, then `*_hold_release`.