Letting ubuntu bash on Windows 10 run 'ssh -X' to get a GUI environment in a remote server

Instruction.md

Letting Ubuntu bash on Windows 10 run 'ssh -X' to get a GUI environment on a remote server

• First

Install all the following. On Window, install Xming. On Ubuntu bash, use sudo apt install to install ssh xauth xorg.

sudo apt install ssh xauth xorg

• Second

Go to the folder contains ssh_config file, mine is /etc/ssh.

• Third

Edit ssh_config as administrator(USE sudo). Inside ssh_config, remove the hash # in the lines ForwardAgent, ForwardX11, ForwardX11Trusted, and set the corresponding arguments to yes.

# /etc/ssh/ssh_config

Host *
    ForwardAgent yes
    ForwardX11 yes
    ForwardX11Trusted yes

• Forth

In ssh_config file, remove the front hash # before Port 22 and Protocol 2, and also append a new line at the end of the file to state the xauth file location, XauthLocaion /usr/bin/xauth, remember write your own path of xauth file.

# /etc/ssh/ssh_config

#   IdentifyFile ...
    Port 22
    Protocol 2
#   Cipher 3des
#   ...
#   ...
    ...
    ...
    GSSAPIDelegateCredentials no
    XauthLocaion /usr/bin/xauth

• Fifth

Now since we are done editing ssh_config file, save it when we leave the editor. Now go to folder ~ or $HOME, append export DISPLAY=localhost:0 to your .bashrc file and save it.

# ~/.bashrc
...
...
export DISPLAY=localhost:0

• Last

We are almost done. Restart your bash shell, open your Xming program and use ssh -X yourusername@yourhost. Then enjoy the GUI environment.

ssh -X yourusername@yourhost

Please change XauthLocaion to XauthLocation (in two places).

👍 Yes, please change XauthLocaion to XauthLocation (in two places).

Can I ask where do I edit the ssh_config? On the server or local

Can I ask where do I edit the ssh_config? On the server or local

ssh_config is for settings related to the client, so, local.

I was trying to use cv2.imshow after these steps to test the GUI, but it showed error like 'connect localhost port 6000: Connection refused Unable to init server: Could not connect: Connection'. I searched a solution for this: add 'xhost +' in the end of ~/.bashrc. But finally it showed another 'xhost: unable to open display "localhost:0"'. Can I ask where may be the problem?

I was trying to use cv2.imshow after these steps to test the GUI, but it showed error like 'connect localhost port 6000: Connection refused Unable to init server: Could not connect: Connection'. I searched a solution for this: add 'xhost +' in the end of ~/.bashrc. But finally it showed another 'xhost: unable to open display "localhost:0"'. Can I ask where may be the problem?

Did you use X server, such as VcXsrv?

Having the same issue as @Kelly510 any updates on that?