Install normally using the installer, after the setup reboot into recovery mode (from the USB stick). Make sure to install in UEFI mode (you need systemd-boot).
If the USB stick is not working for you, because of the old Kernel version (2.6.x), you can also use an Ubuntu 19.10 / 20.04 boot stick. ZFS suport is enabled there out of the box.
Steps:
| blueprint: | |
| name: Philips Hue Dimmer switch v2 (Zigbee2MQTT) | |
| description: | |
| "Tested with Philips Hue Smart Wireless Dimmer Switch V2 (929002398602). | |
| \n\n | |
| To have different actions on short press and on hold (long press), use 'button release' (`*_press_release`) and 'button hold once' (`*_hold_once`) commands, | |
| as 'press' (`*_press`) will always trigger before 'button hold' (`*_hold`). | |
| \n\n | |
| When you hold a button, 'button hold' (`*_hold`) command is repeated roughly once per second. This may not work as desired with actions like toggling light/switch. | |
| If you want an action to run only once when the button hold action is registered, use 'button hold once' (`*_hold_once`). It's better than using 'button hold release' |