When you are up there, ready to fly, you need to make sure your gopro is turned on, and recording. So you hope your GoPro is turned on and recording, you jump and fly... Then when you arrive, you press the shutter button to stop the gopro, but you dont hear anything. The story has just began.
###Parts
- A Hero bus
- A 150 ohm resistor
- A Red or blue or whatever color LED
- 2 cables, for extending the led
###Tools
- A soldering tool
- Pliers (recommended)
##Procedure
Solder the 10 ohm resistor to the + pin of the led (usually the long one), and the other end of the 150 ohm resistor to a cable. Solder the - end of the led to the other cable. Then solder the - led-pin cable to the pin 30 of the gopro bus, and the + led-pin cable to the pin 23 of the gopro bus. And you are done.
Turn your gopro on and the led will bright.
####Upverter schematic
##Photos
######Click to enlarge
####Video coming soon...