VESC 6 flash bootloader using ST-LINK/V2

README.md

Pinout

ST-LINK/V2	VESC
VAPP (pin 1)	VCC
TCK_SWCLK (pin 9)	CLK
GND (pin 20)	GND
TMS_SWDIO (pin 7)	IO
NRST (pin 15)	RST

Flash

Get latest bootloader:

git clone https://github.com/vedderb/vesc_tool.git

Install: https://github.com/texane/stlink#installation, then flash:

st-flash --reset write vesc_tool/res/bootloaders/60_o_75_300.bin 0x080E0000

Hi, how one would connect it to a Flipsky 6.6:

Thanks

@pmouraguedes by looking at the board in the picture below. My guess would be that the unpopulated header next to the microcontroller is the programming header.

You're right, needs to be soldered in there.

Thanks!

could you share the bootloader file thanks！！！！
[email protected]

could you share the bootloader file thanks！！！！ [email protected]

You can find it here: https://github.com/vedderb/bldc-bootloader/tree/master/build_all