This was much trickier than I had originally anticipated and have spent a few hours testing.
The config from samba wiki absolutely works, but it wasn't ranked higher in search engine and it's not general enough. https://github.com/zfsonlinux/zfs-auto-snapshot/wiki/Samba
Tested on ubuntu 22.04LTS, samba 4.15.9 and windows 11.
| # | |
| # Klipper configuration file for Anycubic i3 MEGA S | |
| # | |
| # This config file contains settings of all printer pins (steppers, sensors) for Anycubic i3 mega S with TMC2208 Drivers with stock plug orientation | |
| # Klipper firmware should be compiled for the atmega2560 | |
| # | |
| # Config file includes | |
| # - Original or 2208(2209) rotated by cable drivers | |
| # - Mesh bed leveling: BLtouch (3DTouch sensor from Triangelab) | |
| # - Manual meshed bed leveling (commented out) |
| #!/bin/ash | |
| # | |
| # angry_wifi.sh | |
| # | |
| # auto disconnects clients with a low signal strength on LEDE / OpenWRT. great | |
| # for clients who hold onto a lower-signal-strength accesspoint instead of | |
| # roaming. before running, make sure to download the latest MAC addresses with: | |
| # | |
| # wget --no-check-certificate -O - 'https://services13.ieee.org/RST/standards-ra-web/rest/assignments/download/?registry=MAC&text=apple' | cut -d, -f2 > apple_mac_addresses | |
| # |
