serial/UART simple program and setup with Kinetis KL25Z

KL25Z_serial_easy_setup.c

/* -- 
 This program shows how to configure and output 'AB\n' on the USB serial port of a KL25Z
 It is using processor expert and was tested on Kinetis Design Studio (KDS) ver 3.0.0
   -- */

// 1. Add Processor Expert module AsynchroSerial
  // In KDS, in the 'Components' view, right click on 'Components' then "Show components library"
  // In the opened window, select the category 'Kinetis/Peripheral Drivers/Communication' and double-click on AsyncroSerial
  // this will add the AsyncroSerial module to your project
// 2. Configuration
  // Right click on the freshly created AsyncroSerial module in 'Components' view -> Inspector
  // Set the baud-rate of your choice
  // Set the receiver RxD pin to TPM2_CH0
  // Set the transmitter TxD pin to TPM2_CH1
  
// EDIT : ISSUE WITH RX : If number of characters to be received > buffer size, nothing happens.

#include "ASerialLdd1.h"

// Call this function from main
void app()
{
	LDD_TUserData* yourData;
	LDD_TDeviceData* serialDriver = ASerialLdd1_Init(yourData);

	uint8_t test[3] = {0x41,0x42,0x0D};
	
	while(1)
	{
	  // Send 'AB\n'
	  // You can check for errors using the debugger.
	  // Errors are defined in Generated_Code/PE_Error.h
		LDD_TError err = ASerialLdd1_SendBlock(serialDriver, (LDD_TData *)test, 2);
    
    // This must be called because interrupts are not enabled in AsyncroSerial module default config
    // you must call this function after a write
    // and regularly to poll for reception ?
		ASerialLdd1_Main(serialDriver);
		
		// Wait for some time
		uint32_t i = 0;
		for(i = 0 ; i < 10000 ; i++)
		{

		}
	}
}