takataka5614

#define OnB_LED 2

int LedState = 0;
unsigned long previousMillis = 0;

void setup() {
  pinMode(OnB_LED, OUTPUT);
}

void loop()

Paraphraser

Recipe: from MQTT to InfluxDB via Node-RED

• 2024-05-16 adds case study explaining how to extract values from topic strings, and how to specify the measurement name in the message payload provided to the "influxdb out" node.
• 2023-12-02 revise graphics to correspond with "influxdb out" node, and explain the pros and cons of InfluxDB 1.8 vs InfluxDB 2.

Introduction

Getting data produced by IoT sensors into a database is practically a mandatory step before effective visualisation (eg dashboards).

This recipe shows you how to get an MQTT payload into an InfluxDB database using three Node-RED nodes. It makes the following assumptions:

SeeJayDee

/*
 * tiny_IRremote
 * Version 0.2 July, 2016
 * Christian D'Abrera
 * Fixed what was originally rather broken code from http://www.gammon.com.au/Arduino/
 * ...itself based on work by Ken Shirriff.
 *
 * This code was tested for both sending and receiving IR on an ATtiny85 DIP-8 chip.
 * IMPORTANT: IRsend only works from PB4 ("pin 4" according to Arduino). You will need to 
 * determine which physical pin this corresponds to for your chip, and connect your transmitter