Surzhko · August 29, 2015 14:06
diff --git a/togglekb b/togglekb
 You can use xinput to float the input device under X.

    1 Execute the command `xinput list` to list your input devices.
    2 Locate `AT Translated Set 2 keyboard` and take note of its `id` number; this will be used to disable the keyboard. Also, take note of the number at the end, `[slave keyboard (#)]`; this is the id number of the master, which will be used to re-enable your keyboard.
    3 To disable the keyboard, execute the command `xinput float <id#>`, where `<id#>` is your keyboard's id number. For example, if the id was 10, then the command would be `xinput float 10`.
    4 To re-enable the keyboard, execute the command `xinput reattach <id#> <master#>`, where master is that second number we noted down. So if the number was 3, you would do `xinput reattach 10 3`.
	You can use xinput to float the input device under X.

	1 Execute the command `xinput list` to list your input devices.
	2 Locate `AT Translated Set 2 keyboard` and take note of its `id` number; this will be used to disable the keyboard. Also, take note of the number at the end, `[slave keyboard (#)]`; this is the id number of the master, which will be used to re-enable your keyboard.
	3 To disable the keyboard, execute the command `xinput float <id#>`, where `<id#>` is your keyboard's id number. For example, if the id was 10, then the command would be `xinput float 10`.
	4 To re-enable the keyboard, execute the command `xinput reattach <id#> <master#>`, where master is that second number we noted down. So if the number was 3, you would do `xinput reattach 10 3`.