gistfile1.txt

Mr. Mackey booting linux 2.0 in latest southpark episode,
It seems they used the output of the example kernel
messages as provided here:

https://docstore.mik.ua/orelly/linux/run/ch05_03.htm

--
Console: 16 point font, 480 scans
Console: colour VGA+ 80x30, 1 virtual console (max 63)
pcibios_init : BIOS32 Service Directory structure at 0x000fb1d0
pcibios_init : BIOS32 Service Directory entry at 0xfb5a0
pcibios_init : PCI BIOS revision 2.00 entry at 0xfb5d0
Probing PCI hardware.
Calibrating delay loop.. ok - 36.04 BogoMIPS
Memory: 14984k/16384k available (552k kernel code, 384k reserved,\
464k data)
Swansea University Computer Society NET3.035 for Linux 2.0
NET3: Unix domain sockets 0.13 for Linux NET3.035.
Swansea University Computer Society TCP/IP for NET3.034
IP Protocols: ICMP, UDP, TCP
VFS: Diskquotas version dquot_5.6.0 initialized
Checking 386/387 coupling... Ok, fpu using exception 16 error\
reporting.
Checking 'hlt' instruction... Ok.
Intel Pentium with F0 0F bug - workaround enabled.
alias mapping IDT readonly ...  ... done
Linux version 2.0.35 (root@rabbit) (gcc version egcs-2.90.29\
980515 (egcs-1.0.3 release)) #3 Fri Nov 13 15:07:45 CET 1998
Starting kswapd v 1.4.2.2
Serial driver version 4.13 with no serial options enabled
tty00 at 0x03f8 (irq = 4) is a 16550A
tty01 at 0x02f8 (irq = 3) is a 16550A
APM BIOS not found.
Real Time Clock Driver v1.09
Configuring Adaptec (SCSI-ID 7) at IO:330, IRQ 11, DMA priority 5
scsi0 : Adaptec 1542
scsi : 1 host.
  Vendor: IBM       Model: DORS-32160        Rev: WA0A
  Type:   Direct-Access                      ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
  Vendor: SANYO     Model: CRD-254S          Rev: 1.05
  Type:   CD-ROM                             ANSI SCSI revision: 02
Detected scsi CD-ROM sr0 at scsi0, channel 0, id 4, lun 0
scsi : detected 1 SCSI cdrom 1 SCSI disk total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 4226725 [2063 MB]\
[2.1 GB]
Partition check:
 sda: sda1 sda2 sda3
VFS: Mounted root (ext2 filesystem) readonly.
Adding Swap: 130748k swap-space (priority -1)
lp1 at 0x0378, (polling)
3c59x.c:v0.99E 5/12/98 Donald Becker http://cesdis.gsfc.nasa.gov/\
linux/drivers/vortex.html
eth0: 3Com 3c905B Cyclone 100baseTx at 0x6000, 00:10:4b:45:1d:53,\
IRQ 12
  8K byte-wide RAM 5:3 Rx:Tx split, 10baseT interface.
  Enabling bus-master transmits and whole-frame receives.
ISDN subsystem Rev: 1.44/1.41/1.47/1.28/none loaded
HiSax: Driver for Siemens chip set ISDN cards
HiSax: Version 2.1
HiSax: Revisions 1.15/1.10/1.10/1.30/1.8
HiSax: Total 1 card defined
HiSax: Card 1 Protocol EDSS1 Id=teles (0)
HiSax: Teles IO driver Rev. 1.11
HiSax: Teles 16.3 config irq:5 isac:980  cfg:d80
HiSax: hscx A:180  hscx B:580
Teles3: HSCX version A: V2.1  B: V2.1
Teles3: ISAC 2086/2186 V1.1
HiSax: DSS1 Rev. 1.16
HiSax: 2 channels added
HiSax: module installed
inserting floppy driver for 2.0.35
Floppy drive(s): fd0 is 1.44M
FDC 0 is an 8272A
--

linux20.jpg