Static IP Setup on Raspberry Pi

rpi-static-ip-setup.txt

1.) Connect to ACLC KomSpec
2.) Login - use your account/code
3.) type command "ifconfig"
	- take note of wlan0
	- look for "inet addr:xxx.xxx.xxx.xxx"

4.) type command "netstat -r"
	- take note of Gateway IP

5.) type command "ip -4 addr show dev wlan0 | grep inet"
	- take note
	- inet xxx.xxx.xxx.xxx/xx -> take note of last digits after slash

[Optional]
6.) type "ip route | grep default | awk '{print $3}'
	- Expect the same as the gateway above

7.) type "cat /etc/resolv.conf"
	- Expect the same as the gateway above
	- nameserver xxx.xxx.xxx.xxx

8.) sudo nano /etc/dhcpcd.conf
	- at the bottom, add the following

#-------- ACLC config -----
interface wlan0
# IP is our pre-assigned static IP, take note of digits after forward slash. 
# It should be the same as the number seen in Step 5.
static ip_address=10.80.101.10X/24 

# These should be the gateway IP found in Step 4
static routers=10.80.101.254
static domain_name_servers=10.80.101.254

9.) Save the file. <CTRL + O>. Press enter.

10.) Exit. <CTRL + X>

11.) type "sudo shutdown -r now" to restart the pi

12.) Once booted up, type "ifconfig" to re-check the IP address. It should show the IP address you set in Step 8. Look for "inet addr:" under "wlan0"