Intel e1000e fix - Proxmox

fix.md

Fix Intel e1000e error

Please note - you may want to validate whether the options used affect your setup.

Create a new service file.

nano /etc/systemd/system/disable-offloading.service

Paste the required information/command in the newly created service file - please change eth0 to your desired adapter.

[Unit]
Description=Disable NIC offloading
After=network.target

[Service]
Type=oneshot
ExecStart=/sbin/ethtool -K eth0 gso off gro off tso off tx off rx off rxvlan off txvlan off sg off
RemainAfterExit=true

[Install]
WantedBy=multi-user.target

Load the new service file and enable on reboot.

systemctl daemon-reexec && systemctl daemon-reload && systemctl enable disable-offloading.service

Thanks @crypt0rr, I get the following:

root@pve2:~# systemctl status disable-offloading.service
● disable-offloading.service - Disable NIC offloading
     Loaded: loaded (/etc/systemd/system/disable-offloading.service; enabled; preset: enabled)
     Active: active (exited) since Thu 2025-05-08 09:25:20 BST; 42min ago
    Process: 941 ExecStart=/sbin/ethtool -K eno1 gso off gro off tso off tx off rx off rxvlan off txvlan off sg off (code=exited, status=0/SUCCESS)
   Main PID: 941 (code=exited, status=0/SUCCESS)
        CPU: 21ms
root@pve2:~# 

Just wondered if there was anything else that needed to be checked but all good :) I shall see if this works in about 12 hours (my Proxmox keeps dying around 9pm every evening just in the middle of watching something on Plex)

Thanks @crypt0rr, I get the following:

root@pve2:~# systemctl status disable-offloading.service
● disable-offloading.service - Disable NIC offloading
     Loaded: loaded (/etc/systemd/system/disable-offloading.service; enabled; preset: enabled)
     Active: active (exited) since Thu 2025-05-08 09:25:20 BST; 42min ago
    Process: 941 ExecStart=/sbin/ethtool -K eno1 gso off gro off tso off tx off rx off rxvlan off txvlan off sg off (code=exited, status=0/SUCCESS)
   Main PID: 941 (code=exited, status=0/SUCCESS)
        CPU: 21ms
root@pve2:~# 

Just wondered if there was anything else that needed to be checked but all good :) I shall see if this works in about 12 hours (my Proxmox keeps dying around 9pm every evening just in the middle of watching something on Plex)

Hm, that's unfortunate. Let us know if the solution worked for you please!

I solved it here: with post-up command

root@proxmox43:~# cat /etc/network/interfaces
auto lo
iface lo inet loopback

iface eno1 inet manual

auto vmbr0
iface vmbr0 inet static
address 192.168.1.43/24
gateway 192.168.1.1
bridge-ports eno1
post-up /sbin/ethtool -K eno1 tx off rx off
bridge-stp off
bridge-fd 0