danielrothfus · August 29, 2015 13:56
diff --git a/about.txt b/about.txt
 This is a simple wall mount for a Raspberry Pi in the case found at
 http://www.thingiverse.com/thing:30572.  This mount works by supporting the Pi
 by its two lower corners, so that the Ethernet port and the USB ports face out
 of the bottom of the Pi.

 To mount supports, put the corner supports on the Pi, attach short command
 strips to the backside of the feet, and then push the Pi with the feet up
 against the wall.  The Pi will then be able to slide in and out of the supports
 whenever you want to attach it to the wall.

 These parts were designed in FreeCAD.
diff --git a/left.fcstd b/left.fcstd
diff --git a/right.fcstd b/right.fcstd
	This is a simple wall mount for a Raspberry Pi in the case found at
	http://www.thingiverse.com/thing:30572. This mount works by supporting the Pi
	by its two lower corners, so that the Ethernet port and the USB ports face out
	of the bottom of the Pi.

	To mount supports, put the corner supports on the Pi, attach short command
	strips to the backside of the feet, and then push the Pi with the feet up
	against the wall. The Pi will then be able to slide in and out of the supports
	whenever you want to attach it to the wall.

	These parts were designed in FreeCAD.