s3_bucket_mount.sh

# download the proper versions of s3fs and fuse
wget http://s3fs.googlecode.com/files/s3fs-1.61.tar.gz
wget http://downloads.sourceforge.net/project/fuse/fuse-2.X/2.8.4/fuse-2.8.4.tar.gz

# unpack them
tar -xzf s3fs-1.61.tar.gz
tar -xzf fuse-2.8.4.tar.gz

# install dependencies
yum install gcc libstdc++-devel gcc-c++ curl-devel libxml2-devel openssl-devel mailcap

# s3fs require fuse so install it first
cd fuse-2.8.4
./configure --prefix=/usr/local
make
make install
export PKG_CONFIG_PATH=/usr/local/lib/pkgconfig
ldconfig
modprobe fuse

# now install s3fs
cd ../s3fs-1.61
./configure --prefix=/usr/local
make
make install

# if you want to uninstall previous version go to the source folder (preferably in /home/jive or /mnt/tejas)
# and then run `make clean` and `make uninstall`

# make credentials file and give it proper permissions
vi /etc/passwd-s3fs
#enter the credentials in this file format is access_id:secret_key
chmod 600 /etc/passwd-s3fs

# All done ready to mount
mkdir /s3-bucketname

# mount the drive
s3fs -o default_acl=public-read <bucket> /<mountpoint>

# to unmount `umount -l /<mountpoint>`

# if you get error fuse: device not found, try 'modprobe fuse' first
# run `modprobe fuse`
# while this if you get modprobe command not found, modprobe is in sbin, add sbin to the $PATH
# export PATH="$PATH:/sbin" then `modprobe fuse` and run above mounting command again

# if you get error saying cannot load shared library libfuse.so.2:
export PKG_CONFIG_PATH=/usr/lib/pkgconfig:/usr/lib64/pkgconfig/
# and now run the previous command again. Yay! the bucket is mounted!

# verify bucket is mounted properly using `df -h`
# reference: http://www.goworkday.com/2013/08/01/s3fs-installation-on-centos-6-3-ec2/