delta calibration

gistfile1.txt

M665 L492.0000 R231.8000 Z832.7500
M666 X-4.100 Y-5.650 Z-4.750

// dump from 503

>>> m503
SENDING:M503
; config override present: /sd/config-override
;Steps per unit:
M92 X100.00000 Y100.00000 Z100.00000
;Acceleration mm/sec^2:
M204 S3000.00000 Z0.00000
;X- Junction Deviation, Z- Z junction deviation, S - Minimum Planner speed mm/sec:
M205 X0.05000 Z-1.00000 S0.00000
;Max feedrates in mm/sec, XYZ cartesian, ABC actuator:
M203 X200.00000 Y200.00000 Z200.00000 A200.00000 B200.00000 C200.00000
;Optional arm solution specific settings:
M665 L492.0000 R231.0000
;Motor currents:
M907 X0.80000 Y0.80000 Z0.80000 E0.41000
;Home offset (mm):
M206 X0.00 Y0.00 Z0.00
;Trim (mm):
M666 X-4.050 Y-5.400 Z-5.350
;Max Z
M665 Z830.000
;E Steps per mm:
M92 E2525.0000 P57988
;E Filament diameter:
M200 D0.0000 P57988
;E retract length, feedrate:
M207 S3.0000 F2700.0000 Z0.0000 Q6000.0000 P57988
;E retract recover length, feedrate:
M208 S0.0000 F480.0000 P57988
;E acceleration mm/sec²:
M204 E5000.0000 P57988
;E max feed rate mm/sec:
M203 E11.2000 P57988
;PID settings:
M301 S0 P90.7429 I5.3144 D387.3586 X255.0000 Y255
;Max temperature setting:
M143 S0 P300.0000
;PID settings:
M301 S1 P90.7000 I5.3140 D387.0000 X255.0000 Y255
;Max temperature setting:
M143 S1 P300.0000