Created
September 19, 2009 07:15
-
-
Save donpdonp/189427 to your computer and use it in GitHub Desktop.
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
root@OpenWrt:~# lspci | |
00:00.0 Host bridge: Broadcom Corporation BCM5365P Sentry5 Host Bridge | |
00:01.0 Ethernet controller: Atheros Communications, Inc. AR5212 802.11abg NIC (rev 01) | |
00:02.0 USB Controller: NEC Corporation USB (rev 43) | |
00:02.1 USB Controller: NEC Corporation USB (rev 43) | |
00:02.2 USB Controller: NEC Corporation USB 2.0 (rev 04) | |
root@OpenWrt:~# dmesg | |
Linux version 2.6.25.20 (andy@stable-sandbox) (gcc version 4.1.2) #3 Mon Sep 14 09:03:26 UTC 2009 | |
CPU revision is: 00029007 (Broadcom BCM3302) | |
ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x05, vendor 0x4243) | |
ssb: Core 1 found: Fast Ethernet (cc 0x806, rev 0x06, vendor 0x4243) | |
ssb: Core 2 found: IPSEC (cc 0x80B, rev 0x01, vendor 0x4243) | |
ssb: Core 3 found: USB 1.1 Hostdev (cc 0x808, rev 0x02, vendor 0x4243) | |
ssb: Core 4 found: PCI (cc 0x804, rev 0x08, vendor 0x4243) | |
ssb: Core 5 found: MIPS 3302 (cc 0x816, rev 0x01, vendor 0x4243) | |
ssb: Core 6 found: MEMC SDRAM (cc 0x80F, rev 0x00, vendor 0x4243) | |
ssb: Initializing MIPS core... | |
ssb: set_irq: core 0x0806, irq 2 => 2 | |
ssb: set_irq: core 0x0804, irq 0 => 3 | |
early_nvram_init: WGT634U NVRAM found. | |
ssb: Sonics Silicon Backplane found at address 0x18000000 | |
Swapping serial ports! | |
Serial init done. | |
Determined physical RAM map: | |
memory: 02000000 @ 00000000 (usable) | |
Entering add_active_range(0, 0, 8192) 0 entries of 256 used | |
Initrd not found or empty - disabling initrd | |
Zone PFN ranges: | |
Normal 0 -> 8192 | |
Movable zone start PFN for each node | |
early_node_map[1] active PFN ranges | |
0: 0 -> 8192 | |
On node 0 totalpages: 8192 | |
Normal zone: 64 pages used for memmap | |
Normal zone: 0 pages reserved | |
Normal zone: 8128 pages, LIFO batch:0 | |
Movable zone: 0 pages used for memmap | |
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 | |
Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 init=/etc/preinit noinitrd console=ttyS0,115200 | |
Primary instruction cache 8kB, VIPT, 2-way, linesize 16 bytes. | |
Primary data cache 4kB, 2-way, VIPT, no aliases, linesize 16 bytes | |
Synthesized clear page handler (26 instructions). | |
Synthesized copy page handler (46 instructions). | |
PID hash table entries: 128 (order: 7, 512 bytes) | |
console [ttyS0] enabled | |
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) | |
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) | |
Memory: 29824k/32768k available (2073k kernel code, 2944k reserved, 308k data, 128k init, 0k highmem) | |
Calibrating delay loop... 198.65 BogoMIPS (lpj=397312) | |
Mount-cache hash table entries: 512 | |
net_namespace: 540 bytes | |
NET: Registered protocol family 16 | |
Switched to high resolution mode on CPU 0 | |
ssb: PCIcore in host mode found | |
Registering a PCI bus after boot | |
PCI: Fixing up bridge 0000:00:00.0 | |
PCI: Setting latency timer of device 0000:00:00.0 to 64 | |
PCI: Fixing up device 0000:00:00.0 | |
PCI: Fixing latency timer of device 0000:00:00.0 to 168 | |
NET: Registered protocol family 2 | |
IP route cache hash table entries: 1024 (order: 0, 4096 bytes) | |
TCP established hash table entries: 1024 (order: 1, 8192 bytes) | |
TCP bind hash table entries: 1024 (order: 0, 4096 bytes) | |
TCP: Hash tables configured (established 1024 bind 1024) | |
TCP reno registered | |
detected lzma initramfs | |
initramfs: LZMA lc=1,lp=2,pb=2,origSize=512 | |
squashfs: version 3.0 (2006/03/15) Phillip Lougher | |
Registering mini_fo version $Id$ | |
JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc. | |
io scheduler noop registered | |
io scheduler deadline registered (default) | |
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing enabled | |
serial8250: ttyS0 at MMIO 0xb8000400 (irq = 3) is a 16550A | |
serial8250: ttyS1 at MMIO 0xb8000300 (irq = 3) is a 16550A | |
serial8250.0: ttyS0 at MMIO 0xb8000400 (irq = 3) is a 16550A | |
serial8250.0: ttyS1 at MMIO 0xb8000300 (irq = 3) is a 16550A | |
b44.c:v2.0 | |
eth0: Broadcom 44xx/47xx 10/100BaseT Ethernet 00:0f:b5:3d:40:e6 | |
flash init: 0x1c000000 0x02000000 | |
Physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank | |
Physically mapped flash: Found an alias at 0x800000 for the chip at 0x0 | |
Physically mapped flash: Found an alias at 0x1000000 for the chip at 0x0 | |
Physically mapped flash: Found an alias at 0x1800000 for the chip at 0x0 | |
Intel/Sharp Extended Query Table at 0x0031 | |
Using buffer write method | |
cfi_cmdset_0001: Erase suspend on write enabled | |
erase region 0: offset=0x0,size=0x20000,blocks=64 | |
Flash device: 0x800000 at 0x1fc00000 | |
bootloader size: 655360 | |
Creating 4 MTD partitions on "Physically mapped flash": | |
0x00000000-0x000a0000 : "cfe" | |
0x000a0000-0x007e0000 : "linux" | |
0x0015d400-0x007e0000 : "rootfs" | |
mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only | |
mtd: partition "rootfs" set to be root filesystem | |
mtd: partition "rootfs_data" created automatically, ofs=2C0000, len=520000 | |
0x002c0000-0x007e0000 : "rootfs_data" | |
0x007e0000-0x00800000 : "nvram" | |
Registered led device: power | |
TCP vegas registered | |
NET: Registered protocol family 1 | |
NET: Registered protocol family 17 | |
802.1Q VLAN Support v1.8 Ben Greear <[email protected]> | |
All bugs added by David S. Miller <[email protected]> | |
VFS: Mounted root (squashfs filesystem) readonly. | |
Freeing unused kernel memory: 128k freed | |
Please be patient, while OpenWrt loads ... | |
Algorithmics/MIPS FPU Emulator v1.5 | |
diag: Detected 'Netgear WGT634U' | |
b44: eth0: Link is up at 100 Mbps, full duplex. | |
b44: eth0: Flow control is off for TX and off for RX. | |
roboswitch: Probing device eth0: found! | |
b44: eth0: powering down PHY | |
mini_fo: using base directory: / | |
mini_fo: using storage directory: /jffs | |
b44: eth0: Link is up at 100 Mbps, full duplex. | |
b44: eth0: Flow control is off for TX and off for RX. | |
br-lan: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature. | |
device eth0.0 entered promiscuous mode | |
device eth0 entered promiscuous mode | |
br-lan: port 1(eth0.0) entering learning state | |
br-lan: topology change detected, propagating | |
br-lan: port 1(eth0.0) entering forwarding state | |
PPP generic driver version 2.4.2 | |
ip_tables: (C) 2000-2006 Netfilter Core Team | |
nf_conntrack version 0.5.0 (1024 buckets, 4096 max) | |
wlan: trunk | |
ath_hal: module license 'Proprietary' taints kernel. | |
ath_hal: 2009-05-08 (AR5210, AR5211, AR5212, AR5416, RF5111, RF5112, RF2413, RF5413, RF2133, RF2425, REGOPS_FUNC, XR) | |
ath_rate_minstrel: Minstrel automatic rate control algorithm 1.2 (trunk) | |
ath_rate_minstrel: look around rate set to 10% | |
ath_rate_minstrel: EWMA rolloff level set to 75% | |
ath_rate_minstrel: max segment size in the mrr set to 6000 us | |
wlan: mac acl policy registered | |
ath_pci: trunk | |
PCI: Fixing up device 0000:00:01.0 | |
PCI: Setting latency timer of device 0000:00:01.0 to 64 | |
ath_pci: cannot reserve PCI memory region | |
root@OpenWrt:~# | |
root@OpenWrt:~# cat /etc/config/wireless | |
config wifi-device wifi0 | |
option type atheros | |
option channel 1 | |
option disabled 0 | |
config wifi-iface | |
option device wifi0 | |
option network lan | |
option mode ap | |
option ssid OpenWrt | |
option encryption psk2 | |
option key '12345678asdfg' | |
root@OpenWrt:~# wifi | |
/sbin/wifi: eval: line 1: cannot create /proc/sys/dev/wifi0/countrycode: nonexistent directory | |
/sbin/wifi: eval: line 1: cannot create /proc/sys/dev/wifi0/outdoor: nonexistent directory | |
cat: can't open '/proc/sys/dev/wifi0/dev_name': No such file or directory | |
sysctl: error: 'dev.wifi0.softled' is an unknown key | |
wlanconfig: ioctl: No such device | |
enable_atheros(wifi0): Failed to set up ap vif | |
root@OpenWrt:~# |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment