i3 printer.md

i3 printer.md

#Gcodes for my i3 style printer

#Homing, step 1 M852 S-0.0118108; G28; G0 Z8; G0 X110 Y110

#Homing, after manual touch of the bed G92 Z0; G0 Z5; G0 X0

klipper printer.cfg

# This file contains common pin mappings for RAMPS (v1.3 and later)
# boards. RAMPS boards typically use a firmware compiled for the AVR
# atmega2560 (though other AVR chips are also possible).

# See the example.cfg file for a description of available parameters.

[stepper_x]
step_pin: ar54
dir_pin: !ar55
enable_pin: !ar38
step_distance: .0125
endstop_pin: ^ar3
#endstop_pin: ^ar2
position_endstop: -12
position_min: -12
position_max: 240
homing_speed: 50

[stepper_y]
step_pin: ar60
dir_pin: ar61
enable_pin: !ar56
step_distance: .0125
endstop_pin: ^ar14
#endstop_pin: ^ar15
position_endstop: -11
position_min: -11
position_max: 200
homing_speed: 50

[stepper_z]
step_pin: ar46
dir_pin: !ar48
enable_pin: !ar62
step_distance: .0025
endstop_pin: ^ar18
#endstop_pin: ^ar19
position_endstop: 0.0
position_max: 200

[extruder]
step_pin: ar26
dir_pin: ar28
enable_pin: !ar24
step_distance: .0012
nozzle_diameter: 0.600
filament_diameter: 1.750
heater_pin: ar10
sensor_type: ATC Semitec 104GT-2
sensor_pin: analog13
control: pid
pid_Kp: 23.56
pid_Ki: 1.61
pid_Kd: 86.63
min_temp: 0
max_temp: 280

#[extruder1]
#step_pin: ar36
#dir_pin: ar34
#enable_pin: !ar30
#heater_pin: ar9
#sensor_pin: analog15
#...

[heater_bed]
heater_pin: ar8
sensor_type: EPCOS 100K B57560G104F
sensor_pin: analog14
control: watermark
min_temp: 0
max_temp: 120

[fan]
pin: ar9

[mcu]
serial: /dev/serial/by-id/usb-1a86_USB2.0-Serial-if00-port0
pin_map: arduino

[printer]
kinematics: cartesian
max_velocity: 300
max_accel: 3000
max_z_velocity: 5
max_z_accel: 100

# "RepRapDiscount 2004 Smart Controller" type displays
[display]
lcd_type: hd44780
rs_pin: ar16
e_pin: ar17
d4_pin: ar23
d5_pin: ar25
d6_pin: ar27
d7_pin: ar29
encoder_pins: ^ar31, ^ar33
click_pin: ^!ar35

[force_move]
enable_force_move: True
#   Set to true to enable FORCE_MOVE and SET_KINEMATIC_POSITION
#   extended G-Code commands. The default is false.