config.txt

#Modifcations to /boot/* files, will not be saved when powered on.
#Please ensure you edit from the DietPi-RamDisk location /DietPi/*

# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# Set to 1 if your display has a black border of unused pixels visible
disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size. By default it will be display's size minus
framebuffer_width=1920
framebuffer_height=1080

# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
hdmi_group=2
hdmi_mode=82

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

#-------RPi Camera Module-------
start_x=0
disable_camera_led=1

#-------GPU memory Splits-------
gpu_mem_256=64
gpu_mem_512=64
gpu_mem_1024=256

#-------Max USB Current -------
max_usb_current=0

#-------Disable Ram temp refresh every 500ms---------------
disable_pvt=1

#-------Disable Pi Splash screen on boot-------------
disable_splash=1

#-------Remove dedicated pll for PWM audio -------
avoid_pwm_pll=1

#-------SoundCard-------
#dtoverlay=RPi-bcm2835

#-------Overclock-------
temp_limit=65
initial_turbo=20
force_turbo=0

#over_voltage=0
#arm_freq=900
#core_freq=250
#sdram_freq=400

#Note To Self, NEVER enable L2 cache, breaks most X based applications that were not compiled with L2 cache enabled.