D-Link: show ports will ignore disabel clipaging

gistfile1.txt

DGS-3120-24TC:admin#disable clipaging
Command: disable clipaging

Success.

DGS-3120-24TC:admin#show ports
Command: show ports

 Port      State/          Settings             Connection          Address
           MDIX      Speed/Duplex/FlowCtrl  Speed/Duplex/FlowCtrl   Learning
 -------  --------  ---------------------  ----------------------  ---------
 1:1      Enabled   Auto/Disabled          1000M/Full/None         Enabled
          Auto
 1:2      Enabled   Auto/Disabled          1000M/Full/None         Enabled
          Auto
 1:3      Enabled   Auto/Disabled          Link Down               Enabled
          Auto
 1:4      Enabled   Auto/Disabled          Link Down               Enabled
          Auto
 1:5      Enabled   Auto/Disabled          Link Down               Enabled
          Auto
 1:6      Enabled   Auto/Disabled          1000M/Full/None         Enabled
          Auto
 1:7      Enabled   Auto/Disabled          Link Down               Enabled
          Auto
 1:8      Enabled   Auto/Disabled          100M/Full/None          Enabled
          Auto
 1:9      Enabled   Auto/Disabled          1000M/Full/None         Enabled
          Auto

CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh

DGS-3120-24TC:admin#show terminal width
Command: show terminal width

Global terminal width     : 80
Current terminal width    : 80

DGS-3120-24TC:admin#show switch
Command: show switch

Device Type                : DGS-3120-24TC Gigabit Ethernet Switch
Unit ID                    : 1
MAC Address                : 90-94-E4-22-FA-00
IP Address                 : 192.168.50.10 (Manual)
VLAN Name                  : management
Subnet Mask                : 255.255.255.0
Default Gateway            : 192.168.50.1
Boot PROM Version          : Build 2.00.003
Firmware Version           : Build 2.00.010
Hardware Version           : A2
Firmware Type              : EI
...