Disable leds on Raspberry Pi 3 Model B Rev 1.2

disable_leds_rpi3.sh

# https://raspberrypi.stackexchange.com/questions/117632/turn-off-external-leds-on-raspberry-pi-3

# check model
cat /sys/firmware/devicetree/base/model
# Raspberry Pi 3 Model B Rev 1.2

# Disable Power (red) and Activity (yellow) leds
sudo nano /etc/rc.local
# Add the following lines before `exit 0`:
sudo sh -c 'echo none > /sys/class/leds/led0/trigger'
sudo sh -c 'echo none > /sys/class/leds/led1/trigger'
sudo sh -c 'echo 0 > /sys/class/leds/led0/brightness'
sudo sh -c 'echo 0 > /sys/class/leds/led1/brightness'

# Disable LAN/Ethernet leds by using lan951x-led-ctl
sudo apt-get install libusb-1.0-0-dev
git clone https://github.com/dumpsite/lan951x-led-ctl.git
cd lan951x-led-ctl/
make

# disable lan leds
sudo ./lan951x-led-ctl --fdx=0 --lnk=0 --spd=0
# setting FDX LED to status 0
# setting LNK LED to status 0
# setting SPD LED to status 0

# enable lan leds
sudo ./lan951x-led-ctl --fdx=1 --lnk=1 --spd=1
# setting FDX LED to status 1
# setting LNK LED to status 1
# setting SPD LED to status 1

# Let's put all of this on your rc.local to start-up without leds, see below my version:
$ sudo cat /etc/rc.local
#!/bin/sh -e
#
# rc.local
#
# This script is executed at the end of each multiuser runlevel.
# Make sure that the script will "exit 0" on success or any other
# value on error.
#
# In order to enable or disable this script just change the execution
# bits.
#
# By default this script does nothing.

# Print the IP address
_IP=$(hostname -I) || true
if [ "$_IP" ]; then
  printf "My IP address is %s\n" "$_IP"
fi

sudo sh -c 'echo none > /sys/class/leds/led0/trigger'
sudo sh -c 'echo none > /sys/class/leds/led1/trigger'
sudo sh -c 'echo 0 > /sys/class/leds/led0/brightness'
sudo sh -c 'echo 0 > /sys/class/leds/led1/brightness'
sudo sh -c 'sudo /home/pi/Projects/lan951x-led-ctl/lan951x-led-ctl --fdx=0 --lnk=0 --spd=0'

exit 0