mendelmax slic3r config

gistfile1.txt

# generated by Slic3r 0.9.0 on Sun Sep  9 11:01:56 2012
acceleration = 0
bed_size = 220,280
bed_temperature = 0
bridge_fan_speed = 100
bridge_flow_ratio = 1
bridge_speed = 70
brim_width = 0
complete_objects = 0
cooling = 1
disable_fan_first_layers = 1
duplicate = 1
duplicate_distance = 6
duplicate_grid = 1,1
end_gcode = G1 X0 Y0\nM104 S0 ; turn off temperature\nM140 S0; turn off heated bed\nM84; disable motors
external_perimeter_speed = 100%
extra_perimeters = 1
extruder_clearance_height = 20
extruder_clearance_radius = 20
extruder_offset = 0x0
extrusion_axis = E
extrusion_multiplier = 1.01
extrusion_width = 0
fan_always_on = 
fan_below_layer_time = 60
filament_diameter = 2.87
fill_angle = 35
fill_density = 0.33
fill_pattern = rectilinear
first_layer_bed_temperature = 0
first_layer_extrusion_width = 200%
first_layer_height = 110%
first_layer_speed = 30%
first_layer_temperature = 0
g0 = 0
gcode_arcs = 0
gcode_comments = 0
gcode_flavor = reprap
infill_acceleration = 50
infill_every_layers = 1
infill_extruder = 1
infill_extrusion_width = 0
infill_speed = 100
layer_gcode = 
layer_height = 0.3
max_fan_speed = 100
min_fan_speed = 35
min_print_speed = 40
notes = 
nozzle_diameter = 0.4
output_filename_format = [input_filename_base].gcode
perimeter_acceleration = 25
perimeter_extruder = 1
perimeter_extrusion_width = 0
perimeter_speed = 65
perimeters = 2
post_process = 
print_center = 110,100
randomize_start = 1
retract_before_travel = 3
retract_length = 0.7
retract_lift = 0.35
retract_restart_extra = 0
retract_speed = 15
rotate = 0
scale = 1
skirt_distance = 6
skirt_height = 1
skirts = 1
slowdown_below_layer_time = 30
small_perimeter_speed = 55
solid_fill_pattern = rectilinear
solid_infill_speed = 80
solid_layers = 2
start_gcode = 
support_material = 0
support_material_angle = 0
support_material_extruder = 1
support_material_extrusion_width = 0
support_material_pattern = rectilinear
support_material_spacing = 2.5
support_material_threshold = 45
temperature = 0
threads = 4
top_solid_infill_speed = 65
travel_speed = 150
use_relative_e_distances = 0
z_offset = 0