Block Tor Exit Nodes with Fail2ban

block-tor-exit-nodes-fail2ban.md

Below is the procedure to automate the ip ban of tor exit nodes with fail2ban.

1. Install fail2ban:

sudo apt install fail2ban

2. Create a new fail2ban jail (editing /etc/fail2ban/jail.local):

[tor]
enabled  = true
bantime  = 25h
action   = iptables-allports[name=fail2banTOR, protocol=all]

3. Create a dummy filter file to /etc/fail2ban/filter.d/tor.conf:

[Definition]
failregex =
ignoreregex =

4. Adjust fail2ban file limits (create /etc/systemd/system/fail2ban.service.d/limits.conf):

[Service]
LimitNOFILE=2048

5. Restart systemctl and fail2ban:

sudo systemctl daemon-reload
sudo service fail2ban restart

6. Create a bash script to download the list of tor exit nodes and add their ips to the fail2ban jail:

#!/bin/bash
set -o nounset -o xtrace -o errexit

IPV4_REGEX='^([0-9]{1,3}\.){3}[0-9]{1,3}(\/([0-9]|[1-2][0-9]|3[0-2]))?$'
IPV6_REGEX='^s*((([0-9A-Fa-f]{1,4}:){7}([0-9A-Fa-f]{1,4}|:))|(([0-9A-Fa-f]{1,4}:){6}(:[0-9A-Fa-f]{1,4}|((25[0-5]|2[0-4]d|1dd|[1-9]?d)(.(25[0-5]|2[0-4]d|1dd|[1-9]?d)){3})|:))|(([0-9A-Fa-f]{1,4}:){5}(((:[0-9A-Fa-f]{1,4}){1,2})|:((25[0-5]|2[0-4]d|1dd|[1-9]?d)(.(25[0-5]|2[0-4]d|1dd|[1-9]?d)){3})|:))|(([0-9A-Fa-f]{1,4}:){4}(((:[0-9A-Fa-f]{1,4}){1,3})|((:[0-9A-Fa-f]{1,4})?:((25[0-5]|2[0-4]d|1dd|[1-9]?d)(.(25[0-5]|2[0-4]d|1dd|[1-9]?d)){3}))|:))|(([0-9A-Fa-f]{1,4}:){3}(((:[0-9A-Fa-f]{1,4}){1,4})|((:[0-9A-Fa-f]{1,4}){0,2}:((25[0-5]|2[0-4]d|1dd|[1-9]?d)(.(25[0-5]|2[0-4]d|1dd|[1-9]?d)){3}))|:))|(([0-9A-Fa-f]{1,4}:){2}(((:[0-9A-Fa-f]{1,4}){1,5})|((:[0-9A-Fa-f]{1,4}){0,3}:((25[0-5]|2[0-4]d|1dd|[1-9]?d)(.(25[0-5]|2[0-4]d|1dd|[1-9]?d)){3}))|:))|(([0-9A-Fa-f]{1,4}:){1}(((:[0-9A-Fa-f]{1,4}){1,6})|((:[0-9A-Fa-f]{1,4}){0,4}:((25[0-5]|2[0-4]d|1dd|[1-9]?d)(.(25[0-5]|2[0-4]d|1dd|[1-9]?d)){3}))|:))|(:(((:[0-9A-Fa-f]{1,4}){1,7})|((:[0-9A-Fa-f]{1,4}){0,5}:((25[0-5]|2[0-4]d|1dd|[1-9]?d)(.(25[0-5]|2[0-4]d|1dd|[1-9]?d)){3}))|:)))(%.+)?s*(\/([0-9]|[1-9][0-9]|1[0-1][0-9]|12[0-8]))?$'

banned_ip_counter=0

for ip in $(curl -fsS https://check.torproject.org/torbulkexitlist); do
  if ! [[ $ip =~ $IPV4_REGEX || $ip =~ $IPV6_REGEX ]]; then
      echo "Error: $ip is not a valid IPv4/IPv6 address" >&2
      continue
  fi

  sudo fail2ban-client set "tor" banip "$ip"
  banned_ip_counter="$((banned_ip_counter+1))"
done

if [[ $banned_ip_counter -lt 1 ]]; then
  echo "Error: no IP banned" >&2
fi

7. Run the script periodically by adding the following lines to crontab -e (install cronic to be notified via email in case of script failure):

[email protected]
30 6 * * * cronic /etc/fail2ban/block-tor.sh

20 minutes ... it takes 2 on mine :)
You're right in your case, my gap is a little more restricted.
Anyway thanks for your script ;)

Here takes about 34 seconds.

Just added more checks to the bash script: regex on ip addresses and improved error messages.

Thank you for this script. Using it the way it was originally intended. Malicious TOR traffic has increased exponentially on one of my websites and the 'whack-a-mole' approach with fail2ban wasn't helping. So far, so good.