kano_monitor_config.txt

### kano_screen_used: LG_ULTRAWIDE
# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# Force sound to go through the analog output even if an HDMI monitor is plugged in
# Not strictly necessary for most apps that default to local device (sonic-pi).
#hdmi_ignore_edid_audio=0

# 1 -> perfect size
# 0 -> added black border for TVs
disable_overscan=1

# Use the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
# the zero setting for CEA is -48, for DMT is 0
overscan_left=0
overscan_right=0
overscan_top=0
overscan_bottom=0

# Force RGB full range (0-255)
hdmi_pixel_encoding=2

# Force Kanux display size.
#framebuffer_width=1024
#framebuffer_height=768

# uncomment if hdmi display is not detected and composite is being output
hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

# Enabling Turbo Mode
# Please, beware "force_turbo=1" will set the sticky bit
# on your RPi unit forever.
#
force_turbo=0
arm_freq=1000
core_freq=500
sdram_freq=500
over_voltage=2

# set memory split: amount allocated to the GPU in MB.
gpu_mem=128

# Toggles PiCamera on(1) and off(0)
start_x=0

# Set max_usb_current flag to 1 if you need to drive usb devices > 500ma current
# Note: RaspberryPI model B+ only
max_usb_current=0

# for more options see http://elinux.org/RPi_config.txt
display_rotate=2