Things to know before using the 3D printer on your own

3dprinter.md

• How to turn it on and off
• How to get a model onto the printer: Makerbot
• How to get a model onto the printer: ReplicatorG
• How to unload and load the filament before/after a print
  • Make sure to check the kind of filament you're using (PLA, ABS) and confirm settings when exporting for a print. (You don't want to use ABS settings with PLA, and vice versa.)
• How to unload and load the filament during a print
• How to watch the filament to make sure it isn’t getting tangled on the spool.
• How to level the build platform
• How to remove/add painters tape on build platform
• How to remove build platform
• How to pause a print, and when to do so
• How to cold pause a print, and when to do so
• How to cancel a print
• How to recognize print problems
  • There is no filament coming out of the nozzle
  • The filament is not being extruded adequately
  • The nozzle is too far from the build platform
  • Printer laying down filament unevenly (e.g. better on one section of platform over others)
  • Model was not generated to sit on build platform
  • Model needs a raft and/or supports

Looks great. Needs also to include:

How to open drawers/ cabinets/ toolbox if Makerspace is closed
How to avoid the appearance of being "open"
When Library opens/closes, and what to do at that time
General expectations for being in the space alone (quiet, don't leave printer or personal items unattended for long periods, etc)

How to turn on Mac - which login to use
How to change infill, resolution, etc. settings
How to determine print time
How to find and insert SD cards (into Mac, Makerbot, own laptop)
How to book time on Makerbot

• Make sure to check the kind of filament you're using (PLA, ABS) and confirm settings when exporting for a print. (You don't want to use ABS settings with PLA, and vice versa.)