OPNsense - Intel i226 NIC tunables

opnsense-i226-nic-tunables.txt

<item>
  <tunable>net.inet.icmp.drop_redirect</tunable>
  <value>1</value>
  <descr/>
</item>
<item>
  <tunable>net.isr.bindthreads</tunable>
  <value>1</value>
  <descr/>
</item>
<item>
  <tunable>net.isr.maxthreads</tunable>
  <value>-1</value>
  <descr/>
</item>
<item>
  <tunable>net.inet.rss.bits</tunable>
  <value>2</value>
  <descr/>
</item>
<item>
  <tunable>net.inet.rss.enabled</tunable>
  <value>1</value>
  <descr/>
</item>
<item>
  <tunable>kern.ipc.nmbclusters</tunable>
  <value>1000000</value>
  <descr/>
</item>
<item>
  <tunable>kern.ipc.nmbjumbop</tunable>
  <value>524288</value>
  <descr/>
</item>
<item>
  <tunable>hw.intr_storm_threshold</tunable>
  <value>10000</value>
  <descr/>
</item>
<item>
  <tunable>net.inet.ip.intr_queue_maxlen</tunable>
  <value>3000</value>
  <descr/>
</item>
<item>
  <tunable>net.inet6.ip6.intr_queue_maxlen</tunable>
  <value>3000</value>
  <descr/>
</item>
<item>
  <tunable>hw.ix.flow_control</tunable>
  <value>0</value>
  <descr/>
</item>
<item>
  <tunable>dev.igc.0.fc</tunable>
  <value>0</value>
  <descr/>
</item>
<item>
  <tunable>dev.igc.1.fc</tunable>
  <value>0</value>
  <descr/>
</item>
<item>
  <tunable>dev.igc.2.fc</tunable>
  <value>0</value>
  <descr/>
</item>
<item>
  <tunable>dev.igc.3.fc</tunable>
  <value>0</value>
  <descr/>
</item>
<item>
  <tunable>net.isr.dispatch</tunable>
  <value>deferred</value>
  <descr/>
</item>

Hi @jorisvervuurt . Thank you for the tips.
Could you please give more instruction on the Interface configuration part ?
Sorry for the newbie question, but can you share how to create a WAN_RAW and a WAN_INTERNET as the same time?

Hey @vhuy036. Do you also use KPN as ISP? KPN supports an MTU of 1512 on WAN and has internet on a separate VLAN. So basically, WAN_RAW is the physical interface with an MTU of 1512 (both IPv4 and IPv6 configuration types set to None). Next create a new VLAN (tag 6) on that physical interface. This will be WAN_INTERNET; open the edit page of that newly created interface and set IPv4 Configuration Type to PPPoE and set the MTU to 1508. Username and password both 'internet'.

@jorisvervuurt
Thank you for the detail instructions.
Unfortunately, I just found out the problem is that my ISP using PPPOE for IPv4 and IPOE for IPv6, which seems not to be supported on OPNSense @@