jpliew

101 Rx Samples in C#

This was taken from http://rxwiki.wikidot.com/101samples, because I wanted to be able to read it more comfortable with syntax highlighting.

Here's the unedited original, translated to Github Markdown glory:

101 Rx Samples - a work in progress

jpliew

// constants won't change. They're used here to set pin numbers:
const int buttonPin = 2;     // the number of the pushbutton pin
const int ledPin =  13;      // the number of the LED pin
long prevTime =0;

// variables will change:
int buttonState = 0;         // variable for reading the pushbutton status

void setup() {
  // initialize the LED pin as an output:

jpliew

#include <IRremote.h>

//Variables:
IRrecv irrecv(10); //Set up the IR Reciever, call it irrecv and attach it to the correct pin 
decode_results results; //Set up a variable to hold the results

void setup() {
  // put your setup code here, to run once:
  Serial.begin(9600);
  irrecv.enableIRIn(); // Start the receiver

jpliew

int analogInPin = A0;  // Analog input pin that the potentiometer is attached to
int btnPin = 2;
int buzzerPin = 6;
bool toggle =false;

void setup() {
  Serial.begin(9600);
  pinMode(buzzerPin, OUTPUT);
}

jpliew

int analogInPin = A0;  // Analog input pin that the potentiometer is attached to
int btnPin = 2;
int buzzerPin = 6;
bool toggle =false;

void setup() {
  Serial.begin(9600);
  pinMode(buzzerPin, OUTPUT);
}

jpliew

int analogInPin = A0;  // Analog input pin that the potentiometer is attached to
int btnPin = 2;
bool toggle =false;

void setup() {
  Serial.begin(9600);
}

void loop()
{

jpliew

int analogInPin = A0;  // Analog input pin that the potentiometer is attached to

void setup() {
  Serial.begin(9600);
}

void loop()
{
  int rawvoltage= analogRead(analogInPin);
  float millivolts= rawvoltage * (5000/1023.0);

jpliew

int sensorPin = 2;
int LEDPin = 13;
int isTilted = 0;

void setup() {
  Serial.begin(9600);
  pinMode(sensorPin, INPUT);
  pinMode(LEDPin, OUTPUT);
}

jpliew

int sensorPin = 2;
int isTilted = 0;

void setup() {
  Serial.begin(9600);
  pinMode(sensorPin, INPUT);
}

void loop() {
  isTilted=digitalRead(sensorPin);

jpliew

int pinR = 10;
int pinG = 9;
int pinB = 11;
int btnPin = 2;
int isPressed =0;

void setup() {
  pinMode(pinR, OUTPUT);
  pinMode(pinG, OUTPUT);
  pinMode(pinB, OUTPUT);