Synology boot locked

gistfile1.txt

Sometimes after a hard reboot (power cut), if your synology cannot be logged in with DSM and it shows "System is getting ready. Please log in later" , please do these steps :

#Admin login via ssh
> synobootseq --set-boot-done
> synobootseq --is-ready
#optional
> /usr/syno/etc/rc.d/S97apache-sys.sh start
> /usr/syno/etc/rc.d/S95sshd.sh start

source https://goo.gl/x5ffPo

omg you just saved me 👍

Instruction on how to use ssh would be useful :-)

Had the same problem on an upgrade inside 6.1.7 (not even an bigger one). Problem was the NAS hang on starting services, so Samba Shares were available, but WebStation, MediaStation and so one were not.
Even upgrading to 6.2 didn't change anything (manually so far, auto upgrade didn't find the upgrade yet).

What does work so far for me is installing the Synology Assistant tool for PC, enabling the Memory Check in Options and perform a Memory Check on the device. It hang some time at 99,7% and I thought it was stuck. But later on, it just rebootet and seems to work with all services.
By the way, I guess on upgrade the system didn't beep and I'm not sure if any of the LEDs for disk and so on worked. Since the reboot after Memory check, they blink and the NAS beeped on reboot.
Let's see...

Thanks, you saved my day. Happened to me after the upgrade to 6.2 version.

Thank you! That worked for me

Thank you! That worked for me

How do I do this I'm a noob..

How do I do this I'm a noob..

Doc will help you a lot :)
https://www.synology.com/en-global/knowledgebase/DSM/tutorial/General_Setup/How_to_login_to_DSM_with_root_permission_via_SSH_Telnet

How do I do this I'm a noob..

Doc will help you a lot :)
https://www.synology.com/en-global/knowledgebase/DSM/tutorial/General_Setup/How_to_login_to_DSM_with_root_permission_via_SSH_Telnet

Thank you!
Little problem though; it says connection refused after entering the first line of command. Does that mean I have not enabled SSH services? Because DSM is not available so I can't check that option now..

Thanks, saved me

You saved me as well.

You saved my ass! Thanks so much for this!

I expanded on this by creating a simple shell script that you can place in /usr/local/bin then execute from SSH:

https://gist.github.com/billyjbryant/993b4e8669659444006823a68f1bd509

I encountered the "System is getting ready" issue, and SSH wasn't enabled previously. After troubleshooting, here's what finally worked:

1. Remove all hard drives and power on the Synology. It will boot into a blank state. Use either the IP address assigned by your router or visit "finds.synology.com" to discover the IP address.

2. When the interface indicates "no HDD available," insert the hard drives one by one, allowing a 10-second gap for each insertion while the power is on and the Synology is live.

3. Wait for 1 minute once all the disks come online, then proceed to install DSM from the web interface. It will install and restart.

4. After booting, your old volumes should be accessible, but you'll need to reinstall all apps. However, all your data will remain intact, including active backup for business tasks and VMs, as well as previous backups.

5. Snapshots already taken will be preserved, but you'll need to enable new scheduled snapshots.

It's a nerve-wracking process, but it worked for me. also will recomend repairing disks from storage console.