Code Alignment

CodeAlign.pas

           if N < NMax then
            begin
              // Passo 2.2.1.1
              z := BischoffAndDowsland(L1, W1, LBox, WBox, N + 1, NMax, X, Y, OffsetX + 0,  OffsetY + W4, TmpBlocos, TmpBlockCount2, Cache) +
                   BischoffAndDowsland(L2, W2, LBox, WBox, N + 1, NMax, X, Y, OffsetX + L1, OffsetY + W5, TmpBlocos, TmpBlockCount2, Cache) +
                   BischoffAndDowsland(L3, W3, LBox, WBox, N + 1, NMax, X, Y, OffsetX + L1, OffsetY + W4, TmpBlocos, TmpBlockCount2, Cache) +
                   BischoffAndDowsland(L4, W4, LBox, WBox, N + 1, NMax, X, Y, OffsetX + 0,  OffsetY + 0,  TmpBlocos, TmpBlockCount2, Cache) +
                   BischoffAndDowsland(L5, W5, LBox, WBox, N + 1, NMax, X, Y, OffsetX + L4, OffsetY + 0,  TmpBlocos, TmpBlockCount2, Cache);
            end
            else
            begin
              // Passo 2.2.1.2
              z := AddBlock(L1, W1, LBox, WBox, TmpBlocos, TmpBlockCount2, OffsetX + 0,  OffsetY + W4) +
                   AddBlock(L2, W2, LBox, WBox, TmpBlocos, TmpBlockCount2, OffsetX + L1, OffsetY + W5) +
                   AddBlock(L3, W3, LBox, WBox, TmpBlocos, TmpBlockCount2, OffsetX + L1, OffsetY + W4) +
                   AddBlock(L4, W4, LBox, WBox, TmpBlocos, TmpBlockCount2, OffsetX + 0,  OffsetY + 0) +
                   AddBlock(L5, W5, LBox, WBox, TmpBlocos, TmpBlockCount2, OffsetX + L4, OffsetY + 0);
            end;

Sim! Nessa situação eu também costumo alinhar.
Porém não costumo alinhar quando são variáveis diferentes, como no exemplo https://gist.github.com/1404649

É, acho que é mais ou menos por aí que eu sigo também