網樂通 nfsroot 開機 log

sh4-nfsroot-boot-log

Filename 'vmlinux.ub'.
Load address: 0x80000000
Loading: T #################################################################
         #################################################################
         #################################################################
         #########
done
Bytes transferred = 2988970 (2d9baa hex)
PDK7105> setenv bootargs console=ttyAS0,115200 nfsroot=192.168.100.1:/srv/nfs/root root=/dev/nfs rw ip=192.168.100.5:192.168.100.1:192.168.100.1:255.255.255.0:sh4:eth0:off mem=256M
PDK7105> bootm 0x80000000
## Booting image at 80000000 ...
   Image Name:   Linux 2.6
   Image Type:   SuperH Linux Kernel Image (gzip compressed)
   Data Size:    2988906 Bytes =   2.9 MiB
   Load Address: 80800000
   Entry Point:  80801000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
CMDLen=155
There is no "hwaddr" keywords!
Read MacAddr=24cf21b2a476

[iptv_kernel]:Starting kernel console=ttyAS0,115200 nfsroot=192.168.100.1:/srv/nfs/root root=/dev/nfs rw ip=192.168.100.5:192.168.100.1:192.168.100.1:255.255.255.0:sh4:eth0:off mehwaddr:24:cf:21:b2:a4:76 - 0x00000000 - 0 ...

Linux version 2.6.32.59_stm24_0211-PDK7105-32BITS-A18B (root@ubuntu) (gcc version 4.2.4 (snapshot) (STMicroelectronics/Linux Base 4.2.4-73)) #0 PREEMPT Sun Apr 27 16:55:37 CST 2014
Boot params:
... MOUNT_ROOT_RDONLY - 00000001
... RAMDISK_FLAGS     - 00000000
... ORIG_ROOT_DEV     - 00000200
... LOADER_TYPE       - 00000000
... INITRD_START      - 00000000
... INITRD_SIZE       - 00000000
Booting machvec: pdk7105
Node 0: start_pfn = 0x40000, low = 0x50000
Zone PFN ranges:
  Normal   0x00040000 -> 0x00050000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0: 0x00040000 -> 0x00050000
STMicroelectronics PDK7105-SDK board initialisation

STx7105 version 3.x
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 65024
Kernel command line: console=ttyAS0,115200 nfsroot=192.168.100.1:/srv/nfs/root root=/dev/nfs rw ip=192.168.100.5:192.168.100.1:192.168.100.1:255.255.255.0:sh4:eth0:off mehwaddr:24:cf:21:b2:a4:76
PID hash table entries: 1024 (order: 0, 4096 bytes)
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
PVR=04909200 CVR=60880000 PRR=00009e20
I-cache : n_ways=2 n_sets=512 way_incr=16384
I-cache : entry_mask=0x00003fe0 alias_mask=0x00003000 n_aliases=4
D-cache : n_ways=2 n_sets=512 way_incr=16384
D-cache : entry_mask=0x00003fe0 alias_mask=0x00003000 n_aliases=4
Memory: 246016k/262144k available (3849k kernel code, 1322k data, 148k init)
Hierarchical RCU implementation.
NR_IRQS:600
Failed to enable clk CLKA_REF, ignoring
Failed to enable clk CLKA_PLL0LS, ignoring
Console: colour dummy device 80x25
console [ttyAS0] enabled
sh_tmu: TMU0 used for clock events
sh_tmu: TMU0 used for periodic clock events
sh_tmu: TMU1 used as clock source
Calibrating delay loop... 448.51 BogoMIPS (lpj=897024)
Mount-cache hash table entries: 512
CPU: STx7105
NET: Registered protocol family 16
Configuring FLASH for boot-from-spi: boot_mode=2
bio: create slab <bio-0> at 0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
cfg80211: Calling CRDA to update world regulatory domain
Switching to clocksource TMU1
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP reno registered
NET: Registered protocol family 1
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
RPC: Registered tcp NFSv4.1 backchannel transport module.
Slow work thread pool: Starting up
Slow work thread pool: Ready
NTFS driver 2.1.29 [Flags: R/O].
JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
ROMFS MTD (C) 2007 Red Hat, Inc.
msgmni has been set to 480
alg: No test for stdrng (krng)
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
lirc_dev: IR Remote Control driver registered, major 61
lirc-stm: probe found data for platform device lirc-stm
lirc-stm: STM LIRC plugin using IRQ 125 in IR mode
lirc_dev: lirc_register_driver: sample_rate: 0
STMicroelectronics LIRC driver initialized.
STMicroelectronics ASC driver initialized
stm-asc.0: ttyAS0 at MMIO 0xfd032000 (irq = 121) is a stm-asc
Uniform Multi-Platform E-IDE driver
ide-gd driver 1.18
MiPHY driver style MiPHY3-65 probed successfully
MiPHY3-65, c1.5 Claimed by sata-stm
scsi0 : sata-stm
ata1: SATA max UDMA/133 irq 72
ata1: SATA link down (SStatus 0 SControl 0)
stmmac - user ID: 0x10, Synopsys ID: 0x33
 No HW DMA feature register supported
 Enhanced/Alternate descriptors
 RX Checksum Offload Engine supported
 TX Checksum insertion supported
 Wake-Up On Lan supported
PPP generic driver version 2.4.2
PPP Deflate Compression module registered
PPP BSD Compression module registered
PPP MPPE Compression module registered
NET: Registered protocol family 24
PPPoL2TP kernel driver, V1.0
usbmon: debugfs is not available
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
stm_usb_probe: usb_phy_clk clock not found for stm-usb.0
stm-ehci stm-ehci.0: STMicroelectronics EHCI Host Controller
stm-ehci stm-ehci.0: new USB bus registered, assigned bus number 1
stm-ehci stm-ehci.0: irq 169, io mem 0xfe1ffe00
stm-ehci stm-ehci.0: USB 0.0 started, EHCI 1.00
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
stm-ohci stm-ohci.0: STMicroelectronics OHCI Host Controller
stm-ohci stm-ohci.0: new USB bus registered, assigned bus number 2
stm-ohci stm-ohci.0: irq 168, io mem 0xfe1ffc00
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 1 port detected
stm_usb_probe: usb_phy_clk clock not found for stm-usb.1
stm-ehci stm-ehci.1: STMicroelectronics EHCI Host Controller
stm-ehci stm-ehci.1: new USB bus registered, assigned bus number 3
stm-ehci stm-ehci.1: irq 143, io mem 0xfeaffe00
stm-ehci stm-ehci.1: USB 0.0 started, EHCI 1.00
usb usb3: configuration #1 chosen from 1 choice
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 1 port detected
stm-ohci stm-ohci.1: STMicroelectronics OHCI Host Controller
stm-ohci stm-ohci.1: new USB bus registered, assigned bus number 4
stm-ohci stm-ohci.1: irq 142, io mem 0xfeaffc00
usb usb4: configuration #1 chosen from 1 choice
hub 4-0:1.0: USB hub found
hub 4-0:1.0: 1 port detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
mice: PS/2 mouse device common for all mice
i2c /dev entries driver
sh_tmu: TMU0 kept as earlytimer
sh_tmu: TMU1 kept as earlytimer
usbcore: registered new interface driver usbhid
usbhid: v2.6:USB HID core driver
STMicroelectronics - Coprocessors st231 Init
st-coprocessor-0: No RAM reserved
st231.0 Coprocessor -------------------------------------------
    not configured!
---------------------------------------------------------------
st-coprocessor-1: No RAM reserved
st231.1 Coprocessor -------------------------------------------
    not configured!
---------------------------------------------------------------
stm-rng hardware driver 1.0 configured
TCP cubic registered
NET: Registered protocol family 17
usb 1-1: new high speed USB device using stm-ehci and address 2
usb 1-1: configuration #1 chosen from 1 choice
scsi1 : SCSI emulation for USB Mass Storage devices
eth0: device MAC address de:ea:ff:ff:01:01
STMMAC MII Bus: probed
eth0: PHY ID 01018f2d at 17 IRQ 0 (0:11) active
stmmac_timer: (eth0) sh_tmu Timer (freq 256Hz)
 No MAC Management Counters available
IP-Config: Complete:
     device=eth0, addr=192.168.100.5, mask=255.255.255.0, gw=192.168.100.1,
     host=sh4, domain=, nis-domain=(none),
     bootserver=192.168.100.1, rootserver=192.168.100.1, rootpath=
PHY: 0:11 - Link is Up - 100/Full
scsi 1:0:0:0: Direct-Access     General  USB Flash Disk   1100 PQ: 0 ANSI: 0 CCS
sd 1:0:0:0: Attached scsi generic sg0 type 0
sd 1:0:0:0: [sda] 15679488 512-byte logical blocks: (8.02 GB/7.47 GiB)
sd 1:0:0:0: [sda] Write Protect is off
sd 1:0:0:0: [sda] Assuming drive cache: write through
sd 1:0:0:0: [sda] Assuming drive cache: write through
 sda: sda1 sda2
sd 1:0:0:0: [sda] Assuming drive cache: write through
sd 1:0:0:0: [sda] Attached SCSI removable disk
Looking up port of RPC 100003/2 on 192.168.100.1
Looking up port of RPC 100005/1 on 192.168.100.1
VFS: Mounted root (nfs filesystem) on device 0:13.
Freeing unused kernel memory: 148k freed
INIT: version 2.88 booting
[info] Using makefile-style concurrent boot in runlevel S.
[ ok ] Starting the hotplug events dispatcher: udevd.
[ ok ] Synthesizing the initial hotplug events...done.
[ ok ] Waiting for /dev to be fully populated...done.
[ ok ] Activating swap...done.
[ ok ] Cleaning up temporary files... /tmp.
[ ok ] Activating lvm and md swap...done.
[....] Checking file systems...fsck from util-linux 2.20.1
done.
[ ok ] Mounting local filesystems...done.
[ ok ] Activating swapfile swap...done.
[ ok ] Cleaning up temporary files....
[ ok ] Setting kernel variables ...done.
[....] Configuring network interfaces...Internet Systems Consortium DHCP Client 4.2.2
Copyright 2004-2011 Internet Systems Consortium.
All rights reserved.
For info, please visit https://www.isc.org/software/dhcp/

Listening on LPF/eth0/de:ea:ff:ff:01:01
Sending on   LPF/eth0/de:ea:ff:ff:01:01
Sending on   Socket/fallback
DHCPREQUEST on eth0 to 255.255.255.255 port 67
DHCPREQUEST on eth0 to 255.255.255.255 port 67
DHCPREQUEST on eth0 to 255.255.255.255 port 67