This guide covers building a Let's Split v2.

lets split build guide.md

This guide has moved

To improve collaboration this guide is now available on GitHub.

Continue reading

This is a heads-up to any future readers

While this guide does work to explain the build process for the Let's Split keyboard, I recommend viewing the updated guide linked at the top of the page. The difference that made me notice that this guide is out-of-date is the wiring for the RGB underglow. In this section, there is no reason to wire both sides of the LED strip to the VCC and GND-- using either the unused jumper pads (or the jumpers themselves) will work. Additionally, though there may be a reason behind this, the guide here defines the number of LEDs as "10" but only shows 8 being wired. There may be other differences but those two stood out.

@tybenz - I had a similar issue on Linux so this may not work for you, but my solution was to run the avrdude command separately with sudo. I think the issue is that the make command wasn't capitalizing the portion after /dev/tty (in my case, "ACM1"). I copied the .hex file to my keymap folder, reset my pro-micro manually, then quickly ran the "extended" avrdude command: sudo avrdude -p atmega32u4 -P /dev/ttyACM1 -c avr109 -U flash:w:lets_split_rev2_custom.hex

Sorry everyone! I didn't realize people were still coming here after the new guide was setup. Here's the updated guide!