net2.md

R1:

en 
    conf t
        int g0/0
            no shut
        ex
        int g0/0.50
            enc dot1Q 50
            ip addr 192.168.1.1 255.255.255.224 
        ex
        int g0/0.250 
            enc dot1Q 250
            ip addr 192.168.1.49 255.255.255.252
        ex
        ip route 192.168.1.32 255.255.255.240 192.168.1.50
        int g0/0.50
            ip helper 192.168.1.58
        ex
        ip route 192.168.1.56 255.255.255.252 192.168.1.50

R2:

en 
    conf t
        int g0/0 
            no shut
        ex
        int g0/0.250
            enc dot 250
            ip addr 192.168.1.50 255.255.255.252
        ex
        int g0/0.300
            enc dot 300
            ip addr 192.168.1.53 255.255.255.252
        ex
        ip route 192.168.1.0 255.255.255.224 192.168.1.49
        router ospf 1
            network 192.168.1.52 0.0.0.3 area 0
            redistribute static subnets // საზღვარი Only
        ex

R3:

en 
    conf t
        int g0/0 
            no shut
        ex
        int g0/0.70
            enc dot 250
            ip addr 192.168.1.33 255.255.255.240
        ex
        int g0/0.300
            enc dot 300
            ip addr 192.168.1.54 255.255.255.252
        ex

        int g0/1
            no shut
            ip addr 192.168.1.57 255.255.255.252
            ip helper 192.168.1.58
            router ospf 1
                netw 192.168.1.56 0.0.0.3 area 0
            ex
        int g0/0.70
            ip helper 192.168.1.58
        ex

SW1:

en
    conf t
        int f0/1 // ამით უკავშირდება SW2
            swi mode trunk
        ex
        int ran f0/2-12
            swi mode acc
            swi port
            swi port max 3
            swi port mac sticky
        ex
        int ran f0/13-24
            swi mode acc
            swi port
            swi port max 3
            swi port mac sticky
        ex
        int ran f0/2-12 
            swi acc vlan 50
        ex
        int ran f0/13-24
            swi acc vlan 70
        ex

SW2: // ზედა

en
    conf t
        int ran f0/1-4
            swi mode trunk
            vlan 70
        ex
        vlan 50
        ex
        vlan 250 
        ex
        vlan 300
        ex

Sw-3(config)#int range f0/2-24
Sw-3(config-if-range)#swi mode acc
Sw-3(config-if-range)#swi por
Sw-3(config-if-range)#swi port-security
Sw-3(config-if-range)#swi port-security ?
mac-address Secure mac address
maximum Max secure addresses
violation Security violation mode

Sw-3(config-if-range)#swi port-security
Sw-3(config-if-range)#swi por
Sw-3(config-if-range)#swi port-security mac st
Sw-3(config-if-range)#swi port-security mac sticky
Sw-3(config-if-range)#swi por
Sw-3(config-if-range)#swi port-security max
Sw-3(config-if-range)#swi port-security maximum 2
Sw-3(config-if-range)#swi po
Sw-3(config-if-range)#swi port-security vi
Sw-3(config-if-range)#swi port-security violation shu
Sw-3(config-if-range)#swi port-security violation shutdown
Sw-3(config-if-range)#ex
Sw-3(config)#vlan 50
Sw-3(config-vlan)#vlan 70
Sw-3(config-vlan)#ex
Sw-3(config)#vlan 70
Sw-3(config-vlan)#ex
Sw-3(config)#int range g0/1-2
^
% Invalid input detected at '^' marker.

Sw-3(config)#int range g0/1-2
Sw-3(config-if-range)#swi mode thu
Sw-3(config-if-range)#swi mode thun
Sw-3(config-if-range)#swi mode th
Sw-3(config-if-range)#swi mode th
Sw-3(config-if-range)#swi mode th
Sw-3(config-if-range)#swi mode?
mode
Sw-3(config-if-range)#swi mode t?
trunk
Sw-3(config-if-range)#swi mode tru
Sw-3(config-if-range)#swi mode trunk

Sw-3(config-if-range)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1, changed state to up

Sw-3(config-if-range)#
Sw-3(config-if-range)#ex
Sw-3(config)#

en
conf t
vlan 50
ex
vlan 70
ex
vlan 100
ex
vlan 150
ex

int
swi mode
ex

naxe qvemot romlebi

if g6/1 g5/1 g1/1 trunk
else access

Sw-1(config-if)#
Sw-1(config-if)#
Sw-1(config-if)#int g0/1
Sw-1(config-if)#swi ac
Sw-1(config-if)#swi access vl`
Sw-1(config-if)#swi access vl
Sw-1(config-if)#swi access vlan 50
Sw-1(config-if)#ex

Sw-1(config-if)#ex
Sw-1(config)#int g2/1
Sw-1(config-if)#swi ac
Sw-1(config-if)#swi access vlan
Sw-1(config-if)#swi access vlan 150
Sw-1(config-if)#ex
Sw-1(config)#int g3/1
Sw-1(config-if)#swi acc
Sw-1(config-if)#swi access vlan 100
Sw-1(config-if)#int g4/1
Sw-1(config-if)#swi ac
Sw-1(config-if)#swi access vlan
Sw-1(config-if)#swi access vlan 70
Sw-1(config-if)#ex
Sw-1(config)#