network config

HostA$ ip -d link
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 promiscuity 0 addrgenmode eui64 
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast master br0 state UP mode DEFAULT group default qlen 1000
    link/ether 94:c6:91:xx:xx:xx brd ff:ff:ff:ff:ff:ff promiscuity 1 
    bridge_slave state forwarding priority 32 cost 4 hairpin off guard off root_block off fastleave off learning on flood on addrgenmode eui64 
3: tun0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UNKNOWN mode DEFAULT group default qlen 100
    link/none  promiscuity 0 
    tun 
4: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq master br0 state UP mode DEFAULT group default qlen 1000
    link/ether 30:52:cb:xx:xx:xx brd ff:ff:ff:ff:ff:ff promiscuity 1 
    bridge_slave state forwarding priority 32 cost 100 hairpin off guard off root_block off fastleave off learning on flood on addrgenmode eui64 
5: br0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP mode DEFAULT group default qlen 1000
    link/ether 30:52:cb:xx:xx:xx brd ff:ff:ff:ff:ff:ff promiscuity 0 
    bridge forward_delay 1500 hello_time 200 max_age 2000 ageing_time 30000 stp_state 0 priority 32768 vlan_filtering 0 vlan_protocol 802.1Q addrgenmode eui64 
6: docker0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue state DOWN mode DEFAULT group default 
    link/ether 02:42:62:xx:xx:xx brd ff:ff:ff:ff:ff:ff promiscuity 0 
    bridge forward_delay 1500 hello_time 200 max_age 2000 ageing_time 30000 stp_state 0 priority 32768 vlan_filtering 0 vlan_protocol 802.1Q addrgenmode eui64

HostA$ cat /etc/network/interfaces
auto lo br0 wlan0

iface lo inet loopback

iface br0 inet static
    bridge_ports eth0
    address 192.168.12.2
    broadcast 192.168.12.255
    netmask 255.255.255.0
    gateway 192.168.12.1

iface wlan0 inet manual
    hostapd /etc/hostapd/hostapd.conf

HostA $ cat /etc/hostapd/hostapd.conf
interface=wlan0
bridge=br0
driver=nl80211
logger_syslog=-1
logger_syslog_level=1
logger_stdout=-1
logger_stdout_level=2
ctrl_interface=/var/run/hostapd
ctrl_interface_group=0
hw_mode=a
channel=36
beacon_int=100
dtim_period=2
max_num_sta=255
macaddr_acl=0
auth_algs=1
ignore_broadcast_ssid=0

ieee80211n=1
ht_capab=[LDPC][TX-STBC][RX-STBC1][DSSS_CCK-40][HT40+][HT40-][MAX-AMSDU-7935]
ieee80211ac=1
vht_capab=[MAX-MPDU-11454][RXLDPC][SHORT-GI-80][TX-STBC-2BY1][RX-STBC-2BY1][MAX-A-MPDU-LEN-EXP7][RX-ANTENNA-PATTERN][TX-ANTENNA-PATTERN]
vht_oper_chwidth=1
vht_oper_centr_freq_seg0_idx=42
eapol_key_index_workaround=0
eap_server=0
wpa=2
country_code=IL
ssid=xxxxxxxxxxxx
wpa_passphrase=xxxxxxxxxxxx
wpa_pairwise=TKIP CCMP

oofnikj/HostA.md

network config