u-boot-with-spl-beagle.bin: U-Boot SPL 2020.01-g68565d28 (Dec 23 2024 - 07:48:28 +0000)

boot-fails-with-u-boot-with-spl-beagle-2024-12-23-build.bin

brom_ver 8
[APP][E] protocol_connect failed, exit.
-----------------------------------------
  _____             _  _____ _____  _  __
 |  __ \           (_)/ ____|  __ \| |/ /
 | |__) |   _ _   _ _| (___ | |  | | ' / 
 |  _  / | | | | | | |\___ \| |  | |  <  
 | | \ \ |_| | |_| | |____) | |__| | . \ 
 |_|  \_\__,_|\__, |_|_____/|_____/|_|\_\
               __/ |                     
              |___/                      
                    -- Presented by ISCAS
-----------------------------------------

U-Boot SPL 2020.01-g68565d28 (Dec 23 2024 - 07:48:28 +0000)
FM[1] lpddr4x singlerank freq=3733 64bit dbi_off=n sdram init
found ddr boundary <0x100000000>
ddr initialized, jump to uboot
image has no header


U-Boot 2020.01-g68565d28 (Dec 23 2024 - 07:48:28 +0000)

CPU:   rv64imafdcvsu
Model: T-HEAD c910 light
DRAM:  4 GiB
C910 CPU FREQ: 750MHz
MMC:   sdhci@ffe7080000: 0, sd@ffe7090000: 1
Loading Environment from MMC... OK
Error reading output register
Warning: cannot get lcd-en GPIO
LCD panel cannot be found : -121
splash screen startup cost 216 ms
In:    serial
Out:   serial
Err:   serial
light_c910_set_gpio_output_high: trying to set gpio output high
light_c910_set_gpio_output_high: no /config node?
ethaddr: 96:da:e1:cc:69:f2
eth1addr: 96:da:e1:cc:69:f3
Net:   ethernet@ffe7070000 (eth0) using MAC address - 96:da:e1:cc:69:f2
eth0: ethernet@ffe7070000ethernet@ffe7070000:0 is connected to ethernet@ffe7070000.  Reconnecting to ethernet@ffe7060000
ethernet@ffe7060000 (eth1) using MAC address - 96:da:e1:cc:69:f3
, eth1: ethernet@ffe7060000
Hit any key to stop autoboot:  0 
Unknown command 'usb' - try 'help'
50340 bytes read in 2 ms (24 MiB/s)
get light aon config faild -19
aon config and set faild -19### ERROR ### Please RESET the board ###