bbb booot

bbb_emmc_boot.txt

Welcome to minicom 2.3

OPTIONS: I18n 
Compiled on Nov 23 2010, 13:27:13.
Port /dev/ttyUSB1

                 Press CTRL-A Z for help on special keys                                                                           
                                                                                                                                   
                                                                                                                                   
U-Boot SPL 2013.04-rc1-14237-g90639fe-dirty (Apr 13 2013 - 13:57:11)                                                               
musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn)                                                     
musb-hdrc: MHDRC RTL version 2.0 
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
USB Peripheral mode controller at 47401000 using PIO, IRQ 0
musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn)
musb-hdrc: MHDRC RTL version 2.0 
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
USB Host mode controller at 47401800 using PIO, IRQ 0
OMAP SD/MMC: 0
mmc_send_cmd : timeout: No status update
reading u-boot.img
reading u-boot.img


U-Boot 2013.04-rc1-14237-g90639fe-dirty (Apr 13 2013 - 13:57:11)

I2C:   ready
DRAM:  512 MiB
WARNING: Caches not enabled
NAND:  No NAND device found!!!
0 MiB
MMC:   OMAP SD/MMC: 0, OMAP SD/MMC: 1
*** Warning - readenv() failed, using default environment

musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn)
musb-hdrc: MHDRC RTL version 2.0 
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
USB Peripheral mode controller at 47401000 using PIO, IRQ 0
musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn)
musb-hdrc: MHDRC RTL version 2.0 
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
USB Host mode controller at 47401800 using PIO, IRQ 0
Net:   <ethaddr> not set. Validating first E-fuse MAC
cpsw, usb_ether
Hit any key to stop autoboot:  0 
gpio: pin 53 (gpio 53) value is 1
mmc_send_cmd : timeout: No status update
Card did not respond to voltage select!
mmc0(part 0) is current device
mmc_send_cmd : timeout: No status update
Card did not respond to voltage select!
No micro SD card found, setting mmcdev to 1
mmc_send_cmd : timeout: No status update
mmc1(part 0) is current device
gpio: pin 54 (gpio 54) value is 1
SD/MMC found on device 1
reading uEnv.txt
14 bytes read in 3 ms (3.9 KiB/s)
Loaded environment from uEnv.txt
Importing environment from mmc ...
gpio: pin 55 (gpio 55) value is 1
4215264 bytes read in 763 ms (5.3 MiB/s)
gpio: pin 56 (gpio 56) value is 1
22780 bytes read in 37 ms (600.6 KiB/s)
Booting from mmc ...
## Booting kernel from Legacy Image at 80007fc0 ...
   Image Name:   Angstrom/3.8.6/beaglebone
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    4215200 Bytes = 4 MiB
   Load Address: 80008000
   Entry Point:  80008000
   Verifying Checksum ... OK
## Flattened Device Tree blob at 80f80000
   Booting using the fdt blob at 0x80f80000
   XIP Kernel Image ... OK
OK
   Using Device Tree in place at 80f80000, end 80f888fb

Starting kernel ...

Uncompressing Linux... done, booting the kernel.
[    0.106026] pinctrl-single 44e10800.pinmux: prop pinctrl-0 index 0 invalid phandle
[    0.222623] omap2_mbox_probe: platform not supported
[    0.491944] tps65217-bl tps65217-bl: no platform data provided
[    0.574839] bone-capemgr bone_capemgr.8: slot #0: No cape found
[    0.611945] bone-capemgr bone_capemgr.8: slot #1: No cape found
[    0.649054] bone-capemgr bone_capemgr.8: slot #2: No cape found
[    0.686164] bone-capemgr bone_capemgr.8: slot #3: No cape found
[    0.770694] pinctrl-single 44e10800.pinmux: pin 44e1080c already requested by mmc.4; cannot claim for gpio-leds.7
[    0.781521] pinctrl-single 44e10800.pinmux: pin-3 (gpio-leds.7) status -22
[    0.788733] pinctrl-single 44e10800.pinmux: could not request pin 3 on device pinctrl-single
systemd-fsck[83]: Angstrom: clean, 64427/112672 files, 336829/449820 blocks
[    8.046174] libphy: PHY 4a101000.mdio:01 not found
[    8.051266] net eth0: phy 4a101000.mdio:01 not found on slave 1

.---O---.                                           
|       |                  .-.           o o        
|   |   |-----.-----.-----.| |   .----..-----.-----.
|       |     | __  |  ---'| '--.|  .-'|     |     |
|   |   |  |  |     |---  ||  --'|  |  |  '  | | | |
'---'---'--'--'--.  |-----''----''--'  '-----'-'-'-'
                -'  |
                '---'

The Angstrom Distribution beaglebone ttyO0

Angstrom v2012.12 - Kernel 3.8.6

beaglebone login: