Add br0 to Ubuntu desktop using nmcli

addbr0ubunmcli.md

Add a bridge interface to Ubuntu desktop using nmcli

Had to do this for some advanced networking with KVM, and couldn't figure out how to do it using the Nework Manager gui. Did find an article later that showed how to do it with nmtui, but it's so much easier to record what you did when using the cli.

In the examples below "eth0" is the name of my physical interface. By default on Ubuntu and most distributions that will almost certainly be different, for example: "eno1", "ens1", or "enp2s0".

To see what everything looks like before starting:

$ nmcli con show

I renamed "Wired Connection 1' to the name of my physical interface:

$ sudo nmcli con mod 'Wired Connection 1' con-name eth0

So let's start out by creating the bridge itself:

$ nmcli con add ifname br0 type bridge con-name br0

Now add the physical interface as its slave:

$ nmcli con add type bridge-slave ifname eth0 master br0

Disable STP:

$ nmcli con mod br0 bridge.stp no

Now down the physical interface:

$ nmcli con down eth0

For this machine I want a static address:

$ nmcli con mod br0 ipv4.addresses 10.1.1.16/24
$ nmcli con mod br0 ipv4.gateway 10.1.1.1
$ nmcli con mod br0 ipv4.dns '10.1.1.1,8.8.8.8,8.8.4.4'

Don't forget to set your search domain:

$ nmcli con mod br0 ipv4.dns-search 'example.com'

Then tell Network Manager this will be a manual connection:

$ nmcli con mod br0 ipv4.method manual

Finally, bring up the new bridge interface:

$ nmcli con up br0

Run nmcli device show to confirm your changes, and then restart NetworkManager (sudo systemctl restart NetworkManager.service) to make sure the configuration sticks.

Hi All,
Thanks for this.
My concern is this; I have read many tutorials, they only talk about the virt-manager bridge mode when the host machine is connected to the physical network via Ethernet. In my case, my PC is permanently connected via Wi-Fi. Would there be a possibility to connect the VMs in bridge mode with virt-manager.

Thanks in advance!

In my case, my PC is permanently connected via Wi-Fi. Would there be a possibility to connect the VMs in bridge mode with virt-manager.

You can try to add the wifi interface instead of wired connection.

nmcli con add type bridge-slave ifname {your-wifi-interface} master br0