Working PiFire DSI config

config.txt

# For more options and information see
# http://rptl.io/configtxt
# Some settings may impact device functionality. See link above for details

# Uncomment some or all of these to enable the optional hardware interfaces
dtparam=i2c_arm=on  # Modified by PiFire Board Configuration Utility
#dtparam=i2s=on
dtparam=spi=on  # Modified by PiFire Board Configuration Utility

# Enable audio (loads snd_bcm2835)
dtparam=audio=on

# Additional overlays and parameters are documented
# /boot/firmware/overlays/README

# Automatically load overlays for detected cameras
camera_auto_detect=1

# Automatically load overlays for detected DSI displays
display_auto_detect=1

# Automatically load initramfs files, if found
auto_initramfs=1

# Enable DRM VC4 V3D driver
dtoverlay=vc4-kms-v3d
max_framebuffers=2

# Don't have the firmware create an initial video= setting in cmdline.txt.
# Use the kernel's default instead.
disable_fw_kms_setup=1

# Disable compensation for displays with overscan
disable_overscan=1

# Run as fast as firmware / board allows
arm_boost=1

[cm4]
# Enable host mode on the 2711 built-in XHCI USB controller.
# This line should be removed if the legacy DWC2 controller is required
# (e.g. for USB device mode) or if USB support is not required.
otg_mode=1

[cm5]
dtoverlay=dwc2,dr_mode=host

[all]
dtoverlay=pwm-2chan,func=4,pin=13  # Modified by PiFire Board Configuration Utility
dtoverlay=w1-gpio,gpiopin=4  # Modified by PiFire Board Configuration Utility
dtoverlay=gpio-shutdown,active_low=1,gpio_pull=up,gpio_pin=17  # Modified by PiFire Board Configuration Utility

# Waveshare 7" DSI LCD 800x480 Display
dtoverlay=vc4-kms-dsi-waveshare-800x480