Check List
Check this first
- Landing gear down
- breaks
- Whispers off
- Engine siwtches OFF
- selector Normal
- Batery vtg > 25.5
Initial Setup
- Bat 1 y 2
- External Power
- Turn on lights
- Emergency
- Seat and cigar
- Nav and Logo
- Crew supply oxygen
- Ground CTL
- ATIRS 1-3-2
- Fuel pumps
MCDU + EFB (tablet) (asumming SimBrief is setup)
- EFB Sync (Dashboard)
- Ground Services (if needed)
- Sync Payload
- Hit Apply
MCDU
-
Menu -> ATSU -> PilotID
-
Init
- Request FP
- Set flight number
- Set Cost Index
-
F-Plan
- Adjust Departure
- Select RW
- Select SID
- Check in the monitor
- Switch selector to PLAN,
- Adjust radous
- Activate constraints
- Adjust Departure
-
Init Again, B page (press <-)
- Adjust BLOCK (Use FOB, example 5380 => 5.4)
- Adjust ZFW (just press the soft key)
- Adjust trip wind (check AVG W/C in SB PDF)
-
Performance (EFB) (calculate on tablet)
- Sync
- Select RW
- Confirm/Set weight (FUEL PRED, GW en el MCDU)
- Set flaps 1
- Calculate and send to FMGS
- Confirm in the performance page
- Set flaps y THS
-
Adjust QHN and transition altitude
APU Startup
- Master Siwtch ON
- Wait 3 seconds and press START
- Check APU page
- Once available,
- disconnect Ext. Power
- Activate APU bleed
- Beacon light ON
- Remove GPU (EFB ground)
- Remove chunks
- Wait 3 seconds and press START
Engine Start & Taxi
- Check Thrust IDLE
- Check Breaks ON
- Check Landing Gear
- Set Engine Switch to Ignite
- Start eng. 2 and then eng. 1 (one 2 is available - a320 support dual start)
- Once both are ready
- APU bleed OFF
- APU master switch OFF
Ready to Taxi
- Taxi lights ON
- Runway lights on
- Speed breaks armed
- Flaps 1 (this depends on the config)
- Auto breaks max
- Flight controls check (see the FC page)
- Trim to Zero
Before TakeOff
- Taxi light off
- Landing lights on
- TCAS TI/RA