Lophilo OS (Debian Wheezy) on Lophilo Tabby with Linux Kernel 3.4

gistfile1.txt

Booting Linux on physical CPU 0
Linux version 3.4.0-rc7+ (rngadam@rngadam-think) (gcc version 4.6.1 (Sourcery CodeBench Lite 2011.09-70) ) #4 Tue May 22 15:04:54 CST 2012
CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177
CPU: VIVT data cache, VIVT instruction cache
Machine: Lophilo
Memory policy: ECC disabled, Data cache writeback
AT91: Detected soc type: at91sam9g45
AT91: Detected soc subtype: at91sam9m10
AT91: sram at 0x300000 of 0x10000 mapped at 0xfef68000
Clocks: CPU 400 MHz, master 133 MHz, main 12.000 MHz
gpiochip_add: registered GPIOs 0 to 31 on device: pioA
gpiochip_add: registered GPIOs 32 to 63 on device: pioB
gpiochip_add: registered GPIOs 64 to 95 on device: pioC
gpiochip_add: registered GPIOs 96 to 127 on device: pioD
gpiochip_add: registered GPIOs 128 to 159 on device: pioE
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 32512
Kernel command line: mem=128M ip=dhcp noinitrd init=/sbin/init root=/dev/nfs nfsroot=10.236.10.120:/home/rngadam/lophilo-OS.nfs rw nfsrootdebug rootwait rootfstype=nfs
PID hash table entries: 512 (order: -1, 2048 bytes)
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 128MB = 128MB total
Memory: 125196k/125196k available, 5876k reserved, 0K highmem
Virtual kernel memory layout:
    vector  : 0xffff0000 - 0xffff1000   (   4 kB)
    fixmap  : 0xfff00000 - 0xfffe0000   ( 896 kB)
    vmalloc : 0xc8800000 - 0xff000000   ( 872 MB)
    lowmem  : 0xc0000000 - 0xc8000000   ( 128 MB)
    modules : 0xbf000000 - 0xc0000000   (  16 MB)
      .text : 0xc0008000 - 0xc04340d0   (4273 kB)
      .init : 0xc0435000 - 0xc0457000   ( 136 kB)
      .data : 0xc0458000 - 0xc0484a80   ( 179 kB)
       .bss : 0xc0484aa4 - 0xc04989e4   (  80 kB)
NR_IRQS:192
AT91: 160 gpio irqs in 5 banks
sched_clock: 32 bits at 100 Hz, resolution 10000000ns, wraps every 4294967286ms
Console: colour dummy device 80x30
console [tty0] enabled
Calibrating delay loop... 199.06 BogoMIPS (lpj=995328)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
Setting up static identity map for 0x703275f0 - 0x70327648
devtmpfs: initialized
NET: Registered protocol family 16
AT91: Power Management (with slow clock mode)
AT91: Starting after power-restored wakeup
bio: create slab <bio-0> at 0
at_hdmac at91sam9g45_dma: Atmel AHB DMA Controller ( cpy slave ), 8 channels
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
Advanced Linux Sound Architecture Driver Version 1.0.25.
Switching to clocksource tcb_clksrc
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP: reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
RPC: Registered named UNIX socket transport module.
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
RPC: Registered tcp NFSv4.1 backchannel transport module.
NFS: Registering the id_resolver key type
msgmni has been set to 244
io scheduler noop registered (default)
atmel_usart.0: ttyS0 at MMIO 0xffffee00 (irq = 1) is a ATMEL_SERIAL
atmel_usart.2: ttyS2 at MMIO 0xfff90000 (irq = 8) is a ATMEL_SERIAL
console [ttyS2] enabled
MACB_mii_bus: probed
macb macb: eth0: Cadence MACB at 0xfffbc000 irq 25 (a2:cb:99:bd:82:00)
macb macb: eth0: attached PHY driver [Davicom DM9161A] (mii_bus:phy_addr=macb-ffffffff:00, irq=-1)
usbcore: registered new interface driver zd1201
usbcore: registered new interface driver cdc_ether
usbcore: registered new interface driver rndis_host
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
atmel-ehci atmel-ehci: Atmel EHCI UHP HS
atmel-ehci atmel-ehci: new USB bus registered, assigned bus number 1
atmel-ehci atmel-ehci: irq 22, io mem 0x00800000
atmel-ehci atmel-ehci: USB 2.0 started, EHCI 1.00
usb usb1: New USB device found, idVendor=1d6b, idProduct=0002
usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1
usb usb1: Product: Atmel EHCI UHP HS
usb usb1: Manufacturer: Linux 3.4.0-rc7+ ehci_hcd
usb usb1: SerialNumber: atmel-ehci
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
at91_ohci at91_ohci: can't request overcurrent gpio 0
at91_ohci at91_ohci: AT91 OHCI
at91_ohci at91_ohci: new USB bus registered, assigned bus number 2
at91_ohci at91_ohci: irq 22, io mem 0x00700000
usb usb2: New USB device found, idVendor=1d6b, idProduct=0001
usb usb2: New USB device strings: Mfr=3, Product=2, SerialNumber=1
usb usb2: Product: AT91 OHCI
usb usb2: Manufacturer: Linux 3.4.0-rc7+ ohci_hcd
usb usb2: SerialNumber: at91
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
usbcore: registered new interface driver usbtmc
usbcore: registered new interface driver uas
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usbcore: registered new interface driver usbserial
usbserial: USB Serial Driver core
usbcore: registered new interface driver ftdi_sio
USB Serial support registered for FTDI USB Serial Device
ftdi_sio: v1.6.0:USB FTDI Serial Converters Driver
usbcore: registered new interface driver pl2303
USB Serial support registered for pl2303
mousedev: PS/2 mouse device common for all mice
at91_rtc at91_rtc: rtc core: registered at91_rtc as rtc0
AT91 Real Time Clock driver.
usbcore: registered new interface driver usbhid
usbhid: USB HID core driver
atmel_ac97c atmel_ac97c.0: Atmel AC97 controller at 0xc8828000, irq = 24
TCP: cubic registered
NET: Registered protocol family 10
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
lib80211: common routines for IEEE802.11 drivers
Registering the dns_resolver key type
at91_rtc at91_rtc: setting system clock to 2012-05-22 10:41:06 UTC (1337683266)
atmel_mci atmel_mci.0: version: 0x410
atmel_mci atmel_mci.0: using dma0chan0 for DMA transfers
atmel_mci atmel_mci.0: Atmel MCI controller at 0xfff80000 irq 11, 1 slots
atmel_mci atmel_mci.1: version: 0x410
atmel_mci atmel_mci.1: using dma0chan1 for DMA transfers
atmel_mci atmel_mci.1: Atmel MCI controller at 0xfffd0000 irq 29, 1 slots
Sending DHCP requests .
mmc0: host does not support reading read-only switch. assuming write-enable.
mmc0: new high speed SDHC card at address 0002
mmcblk0: mmc0:0002 00000 7.41 GiB
 mmcblk0: p1 p2
.
macb macb: eth0: link up (100/Full)
., OK
IP-Config: Got DHCP answer from 0.0.0.0, my address is 10.236.10.139
IP-Config: Complete:
     device=eth0, addr=10.236.10.139, mask=255.255.0.0, gw=10.236.20.254
     host=10.236.10.139, domain=cowin.local, nis-domain=(none)
     bootserver=0.0.0.0, rootserver=10.236.10.120, rootpath=
ALSA device list:
  #0: Atmel AC97 controller
VFS: Mounted root (nfs filesystem) on device 0:10.
devtmpfs: mounted
Freeing init memory: 136K
INIT: version 2.88 booting
[info] Using makefile-style concurrent boot in runlevel S.
[....] Starting the hotplug events dispatcher: udevdudevd[449]: starting version 175
. ok
[ ok ] Synthesizing the initial hotplug events...done.
[....] Waiting for /dev to be fully populated...udevd[449]: sender uid=-1, message ignored

done.
[ ok ] Activating swap...done.
[ ok ] Loading kernel modules...done.
[ ok ] Activating lvm and md swap...done.
[....] Checking file systems...fsck from util-linux 2.20.1
LOPHILOEXT4: recovering journal
LOPHILOEXT4: clean, 17224/420992 files, 165856/1682176 blocks
done.
[....] Mounting local filesystems...EXT4-fs (mmcblk0p2): mounted filesystem with ordered data mode. Opts: errors=remount-ro
done.
[ ok ] Activating swapfile swap...done.
[ ok ] Cleaning up temporary files....
[ ok ] Configuring network interfaces...done.
[ ok ] Setting kernel variables ...done.
[ ok ] Starting rpcbind daemon....
[ ok ] Starting NFS common utilities: statd idmapd.
[ ok ] Cleaning up temporary files....
INIT: Entering runlevel: 2
[info] Using makefile-style concurrent boot in runlevel 2.
[ ok ] Starting NFS common utilities: statd idmapd.
[ ok ] Starting rpcbind daemon...[....] Already running..
[ ok ] Starting system log daemon....
[ ok ] Starting periodic command scheduler: cron.
[ ok ] Starting system message bus: dbus.
[ ok ] Starting Avahi mDNS/DNS-SD Daemon: avahi-daemon.
Starting Dropbear SSH server: dropbear.
[ ok ] Starting kernel log daemon....

Debian GNU/Linux wheezy/sid lophilo1 ttyS2

lophilo1 login: