OBD9141_DUE.INO

OBD9141_DUE.INO

/*
 *  Example based on code found here.
 * https://github.com/iwanders/OBD9141
 * 
 * Put the "OBD9141 in Libraries folder.
 * 
*/

#include "OBD9141.h"
#include "SamNonDuePin.h"

// The RX pin of the Serial1 connected to 9141 K RX of tranciever.
#define RX_PIN 19

// The Tx pin of the Serial1 connected to 9141 K TX of tranciever.
#define TX_PIN 18

// The Enable pin connected to 9141 SLP pin of tranciever.
#define EN_PIN PIN_EMAC_ECRSDV

#define OBD9141_DEBUG

OBD9141 obd;

void setup(){
    SerialUSB.begin(115200);
    delay(2000);

    pinModeNonDue(EN_PIN, OUTPUT);
    digitalWriteNonDue(EN_PIN, HIGH);

    obd.begin(Serial1, RX_PIN, TX_PIN);
}
    
void loop(){
    SerialUSB.println("Looping");

    bool init_success =  obd.init();
    SerialUSB.print("init_success:");
    SerialUSB.println(init_success);

    init_success = true;
    // Uncomment this line if you use the simulator to force the init to be
    // interpreted as successful. With an actual ECU; be sure that the init is 
    // succesful before trying to request PID's.

    if (init_success){
        bool res = true;
        while(res){
            res = obd.getCurrentPID(0x11, 1);
            if (res){
                SerialUSB.print("Result 0x11 (throttle): ");
                SerialUSB.println(obd.readUint8());
            }
            
            res = obd.getCurrentPID(0x0C, 2);
            if (res){
                SerialUSB.print("Result 0x0C (RPM): ");
                SerialUSB.println(obd.readUint16()/4);
            }


            res = obd.getCurrentPID(0x0D, 1);
            if (res){
                SerialUSB.print("Result 0x0D (speed): ");
                SerialUSB.println(obd.readUint8());
            }
            SerialUSB.println();

            delay(200);
        }
    }
    delay(3000);
}